McIntosh HR078, Руководство по программированию

Страница: 7 / 10

7
If your component (TV) in the example on page 3
does not respond to the McIntosh Remote Control,
after trying all codes listed for your (TV) brand, or if
your TV brand is not listed, try by searching through
the McIntosh Remote Control internally stored codes:
1. Switch Power On the component (TV) you wish to
control.
2. Press and hold in the Assigned Input Source (TV)
Push-button, then press the SET Push-button until
the IR Send Indicator flashes twice on the LCD
Display. Refer to figures 5 and 7.
Note: It is impor-
tant to use
the same
Input Source
Push-button
as the desired component device to be con-
trolled (eg. TV Push-button for controlling the
TV).
3. Point the McIntosh Remote Control at the compo-
nent (TV).
4. Press the INPUT ▲ Up Push-button just once and
the first four digit component (TV) code number
will appear on the
LCD Display. Refer
to the example illus-
trated in figure 6.
5. Press the SOURCE ON/OFF (Power) Push-
button. If the component (TV) switches OFF a
working code has been found.
Note: If the component (TV) does not switch OFF,
repeat steps 4 and 5 until a working code
number is found.
Programming by Searching Codes
6. Now press the ENTER Push-button to store the
component (TV) code. Check to see how many de-
sired Remote Control Functions work. For future
reference, write down each working component
code number(s) below:
Note: There may be another component code
number available offering more controlable
commands.
HR078 Remote Control Programming
Assigned Push-button
(and Initial Code)
Component Programmed Code
CD
(3000)
SAT
(4000)
TV
(1000)
BD
(5000)
DVD
(2000)
Power ON/OFF
for programmed
component
Use to activate
Programming
Mode
Component
Push-buttons
LCD
Display
IR Send
Indicator
HR078
DFR
Use to step
thru component
codes
Figure 7
Use to enter the
component code
into memory
Figure 5
Figure 6
Checking the entered Component Code
Numbers
After a Component Code Number has been assigned
the number may be recalled at any time by performing
the following steps:
1. Press and hold in the Assigned Input Source (TV)
Push-button along with the SET Push-button until
the IR Send Indicator flashes twice on the LCD
Display. Refer to figures 4 and 1.
2. Press the SEARCH/INFO Push-button, the IR
Send Indicator flashes twice on the LCD Display
followed by the Component Code Number.
Programming by Searching Codes