3
HR078
DFR
Figure 4
Use to activate
Programming
Mode
To Program this Remote Control, first find the codes
for the component(s) you want to program (starting on
page 4) and then follow the steps below:
1. Turn on the component (in this example, the TV).
2. Press and hold in the Assigned Input Source (TV)
Push-button along with the SET Push-button until
the IR Send Indicator flashes twice on the LCD
Display. Refer to
figures 4 and 1.
3. Release both Push-
buttons. The LCD
Window should now be illuminated and the rear
lighting of the Push-buttons should now be flash-
ing.
4. Enter the four-digit code (using the numeric push-
buttons) for the brand of TV component you wish
to program. The just entered component code
number will appear on the LCD Display followed
by “OK”. Refer to figure 2.
Note: If the LCD
Display
does not
indicate OK
or indicates
NG (not a valid code) check the number and
try entering the code again.
5. Referring to figure 4, aim the IR Emitter end of
the McIntosh Remote Control at the component
and press Power Off. The TV should turn Off. If
it does not, repeat steps 2–5, trying each code for
your brand until you find one that works. If you
cannot find a working TV code refer to “Search-
ing Codes” on page 7.
Note: There might be more than one Program
Code Number capable of switching power
Off to the TV. Choose the Code Number with
Programming by Entering Component
Code Numbers
Push-buttons
used to enter
Program Code
Component
Push-buttons
the greatest number of desired active com-
mands for the TV to be controlled.
6. Repeat steps 1 to 5 for the other components you
want to control. For future reference, write down
each working component code number(s) below:
HR078 Remote Control Programming
Assigned Push-button
(and Initial Code)
Component
Programmed
Code
CD
(3000)
SAT
(4000)
TV
(1000)
BD
(5000)
DVD
(2000)
LCD
Display
Figure 1
Figure 2
IR Send
Indicator
Checking the entered Component Code
Numbers
After a Component Code Number has been assigned
the number may be recalled at any time by performing
the following steps:
1. Press and hold in the Assigned Input Source (TV)
Push-button along with the SET Push-button until
the IR Send Indicator flashes twice on the LCD
Display. Refer to figures 4 and 1.
2. Press the SEARCH/INFO Push-button, the IR
Send Indicator flashes twice on the LCD Display
followed by the Component Code Number.
IR Emitter
