McIntosh C108 -, Инструкция по эксплуатации

Страница: 4 / 12

- 2 -
4. Turn the power amplifier volume control (50W-2 or
20W-2) to full volume setting. The volume control on
the A-116, 30 watt power amplifier, is inoperative
when the pre-amp socket is used and this step may be
disregarded when using this amplifier.
5. Turn the volume control on the C-108 to "OFF".
6. Insert the power cord of the C-108 into a 117 V.A.C.
power outlet.
7. Turn the selector switch of the C-108 to "5" and bass
fully clockwise.
8. Turn the volume control on the C-108 clockwise until
the power switch is activated.
9. Allow thirty seconds for warm-up, then advance the
volume control to full volume.
10. Adjust the hum centering potentiometer on the power
amplifier for minimum hum.
11. Turn the volume control of the C-108 to a minimum
and all other controls to the desired settings.
12. Insert inputs into their proper jacks at the rear of
the C-108.
INSTALLATION WITH McINTOSH D-101 POWER SUPPLY
1. Connect speaker to power amplifier.
2. Insert power amplifier power cord in socket labeled
"PWR AMP" on D-101.
3. Insert D-101 power cord into socket labeled "PWR
AMP" of the C-108.
4. Insert inter-unit cable of C-108 into socket labeled
"PRE-AMP" of the D-101.
5. Connect "OUTPUT" of D-101 to the input of power
amplifier (socket labeled "PRE-AMP" on McIntosh
Power Amplifier). J-107 series cables may be used
for this purpose.