(continued)
©
McDonald’s Corporation · Planned Maintenance Manual · Revised June 2016
Page 2 of 3
Corn
eli
us
So
ft-d
rin
k a
nd
Ice
Dispe
nse
r M
od
els R
efr
esh
P
RO
2
55
Monthly
B
E 86
M1
5
Remove the agitator retainer
and ice agitator assembly.
Turn the agitator retainer to
the left and remove the
retainer. Then remove the ice
agitator assembly. Set the
retainer and agitator aside in a
safe place.
6
Clean hopper, top cover,
agitator and agitator cover.
Take all removable parts and
wash, rinse and sanitize at the
3-compartment sink.
Spray the hopper with
approved multi-surface
solution. Wipe down the
inside of the ice hopper
thoroughly. Rinse the hopper
by wiping with a separate
clean, sanitizer-soaked towel.
Approved Multi-Surface
Cleaner
7
Sanitize the hopper.
Spray the inside of the hopper
with sanitizer solution and
allow it to air dry.
Sanitizer Solution
8
Clean ice chute
Open the touch screen door.
Remove the outer ice chute
assembly by spreading both
tabs at the bottom of the
chute. Once the chute is
unlatched, pull it slightly
forward at the top to separate
the magnet from ice gate stud
and lift it up to remove it.
Wash, rinse and sanitize the
outer ice chute assembly at
the three-compartment sink.
Allow to air dry.
Clean the inner chute with
approved multi-surface
solution and brush. Rinse
thoroughly and spray with
sanitizer. Allow to air dry.
After cleaning and sanitizing,
remove the ice gate from the
inner chute by sliding it
upward. Clean ice gate with
approved multi-surface
cleaner and brush, rinse
thoroughly and spray with,
sanitizer. Allow to air dry.
Slide the ice gate back into
the inner chute. Place the
outer ice chute assembly into
position from the top. Engage
the ice gate into the hole in
the black magnet.
Note:
The tab on top of the
outer ice chute must be placed
under the top side of the inner
ice chute. Once properly
aligned snap the tabs back
into place.
Close the Touch screen door
and test the unit to assure
agitator turns when lever is
pressed.
Approved Multi-Surface
Cleaner, Sanitizer Solution
9
Replace the ice agitator and
agitator assembly.
Replace the clean and
sanitized ice agitator
assembly and the agitator
retainer.
