Page 4
Operating guide for Alarm Receiver
D E C R Y P T A
MCDI Inc.
Internet: http://www.mcdi.com
86 Claude-Champagne Avenue, Montreal, QC, Canada H2V 2X1
Telephone: +514-481-1067
Fax: +514-481-1487
Setting
up
DECRYPTA
Firmware
--
Version
5.1.5+
Firmware version 5.1.5+ and setup program INITPLUS added features:
. New setup display allows easier selection of software interface emulation formats:
Ademco 685 mode ––– Surgard mode ––– Native mode
. Receiver handshake heading pattern is now selectable
.
Setup program INITPLUS (v1.9) displays selection pattern seen below:
A d d r e s s e s
DECRYPTA PARAMETERS ––– MCDI INC. ––– +(514) 481-1067
Cold Reset: Ctl R
03F8
Address
03F8
02F8
03E8
IRQ (Not applicable ot DECRYPTA)
5
Wait After Off Hook
No
02E8
Receiver number
1
2 Rings(Not in use; set to 1 ring)
No
0338
Line 1 Number
1
Caller ID To PC
No
0318
Line 2 Number
2
Caller Id To Printer
No
0308
Heartbeat
No
Caller ID ALL
No
02A8
Sescoa SS instead of 4x2 SUM
No
Date / Time
Yes
0298
3x2 Instead 4x1
No
Send Year
No
0288
Clear Zero
No
ACK Delay
1
0268
Compress Extended
No
SA-TLR/DECRYPTA
Yes
0258
Listen-In (Empty or 1..F)
SurGard Mode
No
0248
Printer / Buzzer
No
0238
0228
Start handshake with
1
1=
1400hz / VFSK
0218
2=
SIA / CFSK
3=
DUAL 1400hz / 2300hz
4=
2300hz
5=
Stratel
6
Telim
7=
Robofon
<CR> Edit
<ESC> Exit ––– <F1> Restore default ––– <F2> Read Config File
Setup program display description and commands
Address section
Address part of display shows address fields for all DECRYPTA and TLR+/SA-TLR+ receivers installed with PC.
Move cursor to desired DECRYPTA using UP/DN arrows.
Press <Enter> to move to Parameter section on right part of display.
Parameters displayed on the right are actual operating parameters.
Press F1 to restore Factory defined parameters. Press F2 to restore saved parameters.
Press <ESC> to Exit setup program INITPLUS.
Before accepting Exit command, INITPLUS request authorization to save new parameters.
When exiting from INITPLUS time on ALL DECRYPTA/TLR+/SA-TLR+ will be reset to PC time.