McCrometer FlowConnect, Инструкция по модернизации

Страница: 13 / 19

Copyright © 2016 McCrometer, Inc. All printed material should not be changed or altered without permission of McCrometer. Any
published technical data and instructions are subject to change without notice. Contact your McCrometer representative for current
technical data and instructions.
www.mccrometer.com
3255 WEST STETSON AVENUE • HEMET, CALIFORNIA 92545 USA
TEL: 951-652-6811 • 800-220-2279 • FAX: 951-652-3078 Printed In The U.S.A. Lit. # 30122-40 Rev. 1.0 / 3-1-17
Page 13 of 19
™
FlowConnect
3 - Connecting Inputs and Outputs
IMPORTANT!
Before purchasing any sensors, be sure to confirm that they are compatible
with the FlowConnect system.
i
SENSOR
CABLE
* EARTH GROUND CABLES EACH HAVE
GREEN WIRE SINGLE END CRIMPED
* EARTH GROUND CABLES EACH HAVE
GREEN WIRE SINGLE END CRIMPED
Cable to a SCADA
unit connects to
OUTPUTS terminal.
If you have two sensors,
use a Y connector.
SCADA UNIT
(+) (−)
SCADA UNIT
(+) (−)
Cable from solar panel
connects to POWER terminal.
Cable from
rain gauge
connects to
INPUTS
terminal.
Cable from
pressure sensor
connects to
INPUTS terminal.
Cable to a SCADA
unit connects to
OUTPUTS terminal.
If you have a sensor
with a remote mount,
use a Y connector.
IMPORTANT: Although
this diagram shows two
sensors, only ONE sensor
can be connected at a
remote mount.
No more than TWO
inputs can be connected
to the FlowConnect using
a Y connector.
SCADA UNIT
(+) (−)
SCADA UNIT
(+) (−)
Cable from solar panel
connects to POWER terminal.
Cable from
rain gauge
connects to
INPUTS
terminal.
Cable from
pressure sensor
connects to
INPUTS terminal.
Figure 13 and Figure 14 below show possible methods of connecting inputs, outputs,
and external power to the FlowConnect system. The examples in the figures show a
FlowConnect with rechargeable batteries. If your system does not have rechargeable
batteries, the connection plate will have only two connectors, Inputs and Outputs.
See the following page for discussion of the Power, Inputs, and Outputs connectors.
Figure 13. Connecting inputs and outputs
to a meter mounted FlowConnect unit
Figure 14. Connecting inputs and outputs
a remote mounted FlowConnect unit