MCC iPort/LAN 2, Руководство пользователя

Страница: 54 / 78

46
iPort/LAN 2
ASCII Command Interface
Note: [CR] = Carriage Return Code or Enter Key.
Syntax: [Select], (Optional), xx = [00..FE], n = [0..32767]
Command Description
Ctrl/R,Ctrl/R,Ctrl/R iPort/LAN Reset
This command resets the iPort/LAN to its default state.
//[CR] Status Display
Display iPort/LAN status information.
/B[0|1|2][CR]
Serial Communication Baud Rate Control
Set the serial communication baud rate (0 = 19.2, 1 = 57.6, 2 = 115.2 Baud)
/C[CR] Close I
2
C Connection
Disconnect from the I
2
C Bus.
/Dxx[CR] Set Destination I
2
C Slave Address
Set the destination I
2
C Slave Address for subsequent Master Transmit or
Receive operations.
/E[0|1][CR]
Echo/Prompt Control [0 = Off, 1 = On]
Enable/Disable data entry echo and prompts.
/F[0|1][CR] Flow Control [0 = XON/XOFF, 1 = RTS/CTS]
Select serial communication handshaking protocol.
/G[0|1][CR] I
2
C General Call Control [0 = Disabled, 1 = Enabled]
Enables/Disables iPort/LAN response to I
2
C Bus General Call (00) messages.
/H[0|1][CR]
Hex Only Display Control [0 = Disabled, 1 = Enabled]
Controls display format of received message data.
/Ixx[CR] Set iPort/LAN’s Own I
2
C Slave Address
Sets iPort/LAN's own I
2
C Slave Address. iPort/LAN will respond to I
2
C Bus
messages sent to this address.
/K[0|1|2|3][CR] I
2
C Bus Clock Rate Control
Set I2C Bus Clock Rate Control (0=23, 1=86, 2=100, 3=400 KHz)
/M[CR]
Command Menu Display
Displays iPort/LAN’s Command Menu
/N([0|1|A|R])[CR] iNterrupt Signal Monitor/Control/Status
Sets Monitor/Control/Status of INT line.
[0 = Disable, 1 = Enable, A = Assert, R = Release, CR=Status]
/O[CR] Open I
2
C Connection
Activates iPort/LAN as an I
2
C device attached to the bus.
/(*)Rnnnn[CR]
Master Read Message
Read the specified number of data bytes from the current Destination I
2
C Slave
device. * = No Stop for Repeated Start.