CDLR Conveyor
Operation and Maintenance Manual
Rev. 0
2021-01-26
9
General Maintenance
Set up a weekly check on all bearings to ensure they
remain tightly bolted down, set screws remain fastened
securely and they are correctly lubricated.
Note:
Shut off and lockout the conveyor before
removing guards for general maintenance.
1.
When terminating operation of the conveyor
make sure that no accumulation of parts is left on
the belt. A large force is applied at start-up and
any excess weight could cause to the drive to fail.
For the same reason always start the conveyor
before introducing parts onto the belt.
2.
After the machine has been used for a long
period of time the belt may lose tension due to
elongation of the belt. If this is the case then
adjust the belt tension.
Impact Conveyor
Maintenance Schedule
Daily Inspection
a) Check for abnormal sounds
around conveyor
b) Check for cleanliness
c) Check that the conveyor is
clear before starting
Monthly Inspection
a) Check belt tension
b) Check belt for excessive wear
c) Carry out daily checks
d) Lubricate the drive chain
Annual Inspection
a) Remove covers and guards and
clean inside conveyor
b) Inspect and replace any consumable parts
c) Check the tightness of all fasteners
on the conveyor
d) Carry out daily checks
e) Carry out monthly checks