4
1. USB Connector
Hook up a USB storage device to load audio files. It supports MP3 and WAV formats. But the WAV format only enables the pitch variance
under 16%
2. CD / USB
Press it to switch the source between USB and CD. Only when the playback is paused, the source switch can be enabled.
3. TRACK
Scroll it to navigate through partitions, folders and tracks. Press it to load a track for play. Press and turn it to skip 10 tracks for quick track
search.
◎
TRACK also uses with other functions to select a specific mode.
◎
It can’t skip the track during the loop playback.
4. FOLDER
USB Flash Drive
Press this button to switch between MP3 folder and MP3 file view. When the view stops at folder selection, pressing and holding this button
for 2 seconds will return to the track view.
Hard Drive
When you use a hard drive as your USB playing source, pressing this button can switch between file, folder and partition views. No matter
the view stops at a partition or a folder, holding this button down for 2 seconds will return to the track view.
◎
In file view, Total-Track shows the total MP3 files in the folder. In folder view, Total-Track shows the total folders in the CD or in the USB
drive. In partition view, Total-Track shows the total partitions in the hard drive.
5. PROG:
The maximum tracks can be edited are 99.
PROG has three views
– Program Editing, Program Track Viewing, and Program Play.
Start PROG-Edit:
In pause mode, press this button to edit program.
This view is PROG Editing.
The display MM:SS: FF position will show “P-xx” and then “xx” will flash. Select a track by turning TRACK and then pressing TRACK to
store it. Repeat the same process and finally press TRACK to finish a program list editing. It will go into
PROG Track Viewing
and allow
reviewing each track which just editing by pressing SKIP.
Play PROG:
Press PLAY/PAUSE to play the program and PROG will flash in the display.
Exit PROG Play/Edit:
When the PROG playback is paused, pressing this button for two seconds can return to the normal playback. Once returning to
the normal playback, pressing this button can enter the program again and will continue the track editing from the last PROG track number
already existed.
In
PROG Editing
view, pressing this button for 2 seconds will wipe out the PROG list and return to normal playback.
6. RELAY
Press the
button to activate this function. When one unit is in play mode, and the other unit is in “pause” mode; pause the playing unit,
the other unit will automatically start to play.
◎
It’s also for switching between the gain and the parameter of the digital effect showing in the display.
7. JOG MODE
Press it to switch jog mode among normal, search and scratch jog modes.
8. HOT-CUE & HOT-LOOP BANKS
This unit allows you to play from 4 cue points or 4 hot loops instantly.
HOT-CUE
A. Set CUE memory: Press MEMO first and then press a certain CUE bank to finish the CUE record. The LED of the set CUE button will
become green.
B. Play” CUE” memory: Press the set CUE bank to perform this function.
