• Lay the loudspeaker cables to the support as shown in the above illustrations.
• Connect the loudspeaker cables from the amplifier to the terminal strip on the loudspeaker:
positive loudspeaker cable
>
Connection (+) or red
negative loudspeaker cable
>
Connection (-) or black
• Turn the rotary switch below the terminal strip into the required position.
Connection to a hi-fi amplifier:
Turn the rotary switch of the loudspeaker to the position: 8 Ohm.
Connection to an ELA amplifier:
Turn the rotary switch into one of the positions: 3.75 / 7.5 / 15 / 30W.
The output rating and therefore, the volume of the loudspeaker, is controlled by the position
of the rotary switch on the loudspeaker.
The higher the output value set the louder the loudspeaker is compared to the other loud-
speakers connected.
In no case turn the rotary switch to the position 5 (8 Ohm) when connecting
the loudspeaker to an ELA amplifier.
• Fasten the ELA wall loudspeaker(s) to the bracket as indicated.
• If you wish to remove the ELA wall loudspeaker from the support again, proceed as follows:
+
-
Maintenance and Care
The ELA wall loudspeaker is maintenance-free.
Clean the exterior of the device only with a dry cloth. Make sure not to damage the sensitive
speaker membranes.
Never use aggressive cleaning agents or chemical solutions as the housing’s surfaces or the
membrane could be damaged.
Disposal
Please dispose of the product, when it is no longer of use, according to the current
statutory requirements.
Technical Data
Woofer
130mm
Tweeter
25mm Mylar-Dome
Impedance in hi-fi mode
8Ohm
Load capacity in hi-fi mode (RMS/max.)
30/45W
Input voltage range for ELA operation
100/70V
Output stages ELA operation
3,75/7.5/15/30W
Frequency range
110 – 20,000Hz
Sound pressure
90+/-3dB
Dimensions
230 x 310 x 175mm
Ground
2.2kg
These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.
© Copyright 2009 by Conrad Electronic SE.
