MBW AP1400, Руководство оператора

Страница: 12 / 21

- 9 -
Exciter Assembly
Refer to EXCITER ASSEMBLY, page 12.
1. Prior to assembly, clean all parts in a suitable solvent
cleaning solution.
2. Inspect all part for wear or failure and replace if
necessary as described in Parts Replacement Cycles
and Tolerances section of this manual.
3. Replace all seals and gaskets at every overhaul or
disassembly.
4. All shafts and housings should be oiled prior to
pressing in bearings. Ensure that all bearings and
seals are pressed squarely and properly seated.
5. For proper hardware torque setting refer to Torque
Chart table in this section of the manual.
6. Press one of the bearings into the exciter housing
opposite of the pulley side.
7. Press the second bearing onto the pulley side of the
exciter shaft
8. Support the bearing in the exciter housing while
pressing the exciter shaft into the housing. Press the
exciter shaft into the housing until the bearing on the
pulley side of the shaft is properly seated in the
housing.
9. Place a washer seal onto the exciter shaft.
10. Install a new seal into the pulley side exciter cover.
Lubricate lip of seal with fresh exciter oil.
11. Assemble a new gasket and pulley side exciter cover
to the exciter housing. Apply medium strength thread
locking liquid to the hex head flange screws securing
the cover to the housing and torque to proper setting.
12. Assemble opposite side exciter cover and new
gasket to exciter housing. Install hex head flange
screws, applying medium strength thread locking
liquid and torque to proper setting.
13. Install shaft key and slide pulley onto exciter shaft.
Replace washer and screw securing pulley to shaft
and torque to proper setting.
14. Fill exciter housing with oil as described in Changing
Exciter Oil section of this manual.
Parts Replacement Cycles and Tolerances
Bearings
Replace anytime a bearing is rough, binding, discolored or removed from housing or
shaft.
Clutch Replace clutch if it does not disengage below 1800 rpm.
Engine Components Refer to your engine manufacturer’s Owner’s Manual.
Hardware
Replace any worn or damaged hardware as needed. Replacement hardware should
be grade 5 and zinc plated unless otherwise specified.
Safety Decals Replace if they become damaged or illegible.
Seals & Gaskets Replace if a leak is detected and at every overhaul or teardown.
V-Belts Replace if cracked, torn, or stretched to the point the belt won’t tension properly.
Exciter Oil
Replace once every season or every 250 hours. Use 4 ounces of oil from the 6-pack
of MBW Inc. #01058 Grounder Pounder® Exciter Oil.