MBS THERMO PELLET, Инструкция по эксплуатации

Страница: 7 / 31

Central heating stove - MBS Thermo Pellet
ASSEMBLY OF THE STOVE
During assembly of the stove, observe regulations related to safety and
environment. Provide room in which stove will be mounted with sufficient
combustion air.
Connect stove to the power 230V, 50Hz. Connection spot must be done pursuant
to the requirements of electricity distributor and valid regulations. Power cable must
be without damages, may not cross over heat areas of the stove, neither over other
devices which may melt or damage the cable.
Prior to mounting of the stove, check if chimney is performed in accordance with
regulations, are there any disturbances in the chimney or any cracks. Remove all
irregularities prior to operation. Stove may not be installed in direct vicinity of
wooden elements, cooling devices or plastic parts of furniture and other
inflammable materials since during its operation (at the combustion of fuel) it
achieves very high working temperature which is distributed at the exterior of the
stove.The least distance between stove and surrounding inflammable elements is,
on back side 20 cm, lateral 20 cm, front 80 cm. If surface on which stove will be
placed is of inflammable material (wood, warm floor, laminate...) it is necessary to
place protection made of metal sheet which covers gabarites of the base: lateral 10
cm, front 30 cm.
Stove is to be connected with chimney via smoke exhaust pipes via connection at
the back of stove, in order to provide adequate sealing and flow of smoke from the
stove towards chimney. Flue pipes may not be too deeply installed into the
chimney to avoid reduction of area of cross section thus preventing draft in the
chimney.
Prior to installation of the stove check draft of chimney since it is one of key factors
of proper operation of the stove. Draft depends on accuracy of chimney and
meteorological conditions. One of most simple aspects for checking of draft in
chimney is using candle flame, as displayed on fig. 1. Put candle flame to
connection opening of chimney and if it sways towards opening, draft is
satisfactory (fig, 1b).