MBRP Off Camber Fabrications 183100, Инструкции

Страница: 4 / 4

183100 © 06/18 PAGE 4 OF 4
Figure 11
Figure 12
Figure 13
13. Finally, use the M6 Screws to mount your license plate.
Note
: The sensors have changed from their original location and they
may not be triggered in exactly the same circumstances as before. Take
time to learn and adjust to the new operating ranges.
14. Install two (2) M10 Hex Bolts with 10mm Washers (4) and M10
Hex Nuts (2) through the holes of the lower flange on the hitch
structure and the LHS Bumper Assembly bracket. Repeat this
step for the
RHS Bumper Assembly
, and tighten the fasteners.
Refer to Figure 9 .
15. Insert the supplied Hole Plugs into the unused holes at the bottom
of each end plate. Refer to Figure 13 .
16. Finally, use the M6 Screws to mount your license plate.
Congratulations! You’re finished! We are sure that you will enjoy this
Off Camber Fabrications
Off Camber Fabrications Off Camber Fabrications
Off Camber Fabrications
product by
M M M MB B B BRP Inc. RP Inc. RP Inc. RP Inc.