183100 © 06/18
PAGE 2 OF 4
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
REMOVAL OF STOCK REAR BUMPER
1.
Remove the flange bolts (5 each side) securing
the hitch structure to
the vehicle frame rails.
Refer to Figure 1.
2.
Disconnect the main
wiring
harness and the trailer wiring connection
from the rear bumper
.
3.
Remove the rear bumper from the vehicle by working the locating
pins on the structure mounting brackets out through the positioning
slots of the frame rails.
Refer to Figure 2.
4.
Disassemble the components of the bumper. Remove the step pad by
disengaging the snaps (
Refer to Figure 3
), then unbolt the steel
frame and corner assemblies from the hitch structure.
5.
Remove the wiring harness from the lights and any sensors. It will be
reused.
6.
Remove the towing electrical socket from the stock bumper. It will be
reused.
7.
Remove the license plate light lenses by pushing in the side tabs (take
care not to break the tabs). The lights and lenses will be reused on the
new bumper.
8.
If the stock bumper is equipped with blind-spot sensors or sonar
parking sensors, remove the corner claddings to access and remove
them (they will be reused)*.
Refer to Figure 4
.
*
Please note that, MBRP cannot guarantee the proper function of the sensors
once removed from the OEM bumper and reinstalled onto the OCF bumper. While
the sensors have been shown to work properly with the OCF bumper, issues or
malfunctions can arise due to sensor calibration and environmental conditions,
particularly with the blind-spot monitor (BSM) units. Also, removal of OEM
sensors from the stock bumper may void the OEM warranty.
INSTALLATION OF THE OCF BUMPER
1.
Reinstall the hitch structure to the vehicle frame rails, replacing
the previously removed stock flange bolts (10).
Refer to Figure 5.
2.
Assemble the
LHS Bumper Assembly
to the
RHS Bumper
Assembly
using two (2)
M10 Hex Bolts
and
M10 Nuts
with four
(4)
10mm Washers
in the connection flange holes, and the
M8
Hex Bolt
,
M8 Hex Nut
, and two (2)
8mm Washers
in the front
tab holes. Tighten the hardware.
Refer to Figure 6
.
Содержание Off Camber Fabrications 183100
Страница 1: ......
