SUBJECT TO CHANGE WITHOUT NOTICE SEE
www.mbci.com
FOR CURRENT INFORMATION EFFECTIVE JANUARY 23, 2014 3
SEAMER MANUAL
SEAMING OPERATION
CONTINUED
The electric seamer will run in one direction
only. To determine the direction of the seamer,
stand at the eave and look upslope. If the roof is
being installed left to right, the seamer will run
upslope. If the roof is being installed right to left,
the seamer will run downslope. An orientation
plate is on the seamer to assist you in placing
the seamer onto the seam properly. When roof
has endlaps, panels will always run right to left.
To begin seaming set seamer on seam with the
locking bar up, and to the open side of the seam.
The rear wheels should be even with the edge of
the roof panel. Push the locking bar down to
engage the rolls and turn the seamer on.
Stop seamer about one foot from end of panels.
Disengage locking bar and remove the electric
seamer. Finish seam with hand tool.
CAUTION
Seamer operation should be closely supervised
at all times. A safety line should be attached to the
seamer.
Houston, TX
877/713-6224
Adel, GA
888/446-6224
Atlanta, GA
877/512-6224
Atwater, CA
800/829-9324
Dallas, TX
800/653-6224
Indianapolis, IN
800/735-6224
Lubbock, TX
800/758-6224
Memphis,
TN 800/206-6224
Oklahoma City, OK
800/597-6224
Omaha, NE
800/458-6224
Phoenix, AZ
888/533-6224
Richmond, VA
800/729-6224
Rome, NY
800/559-6224
Salt Lake City, UT
800/874-2404
San Antonio, TX
800/598-6224
Tampa, FL Sales Office
800/359-6224
EM SuperLok
®
DIRECTION
OF ROOF
INSTALLATION
DIRECTION
OF ROOF
INSTALLATION
PANEL PROFILE
UNSEAMED
PANEL PROFILE
PHASE 1
PANEL PROFILE
PHASE 2
