4
VEHICLE DISASSEMBLY
Console side and lower center dash removal (steps 1-3) aren’t necessary if you’ve already installed the
subwoofer wiring harness(es) per instructions from the Stage kit. Source unit requires removal.
REMOVE CONSOLE SIDES
DISASSEMBLY
1
2
3
Remove driver’s side console
side panel using a pry tool from
the top to gently release the
pressure-fit clips.
Remove passenger’s side
console side panel using a
pry tool from the top to gently
release the pressure-fit clips.
Remove front of center console
side panel on passenger’s side
(footwell area) using a pry tool
to gently release the pressure-
fit clips.
5
4
Remove top center plastic
cover above dash pocket by
pushing up on the front pocket
edge above the lighter socket,
then pulling toward you.
Next, remove two additional
T-30 screws located beneath
the forward edge of the top
center plastic cover location,
just forward of fuse box.
7
8
9
Identify four visible push pin
clips on the outer edges of the
center pocket. These secure
the flanges of the left and right
side dash speaker panels.
Gently remove the four visible
push pin clips with a panel
removal tool or special panel
clip pliers (not needle nose) as
shown.
Remove one additional hidden
push pin under the driver’s side
dash, between the steering
wheel and console, just forward
of the tubular chassis support.
REMOVE CENTER DASH HARDWARE/CLIPS AND SOURCE UNIT
6
Remove four T-25 screws
securing the source unit
housing to the center of the
dash. Two in front, two in back
near master brake cylinder.
