17
REAR SPEAKER PODS
REAR SPEAKER POD INSTALLATION
Every roll cage angle is a bit different; therefore you should take the time to install the swivel mount brackets
on the roll cage to ensure a good fit.
These brackets are designed to allow 180 degree tilt. This
ensures that the speaker points directly forward. This flexibility
in positioning improves sound quality and overall volume. Note
the location of the Adjustment Locking Screw is at the rear of the
assembly as shown in Figure 13-1.
STEP 1 – MOUNT SPEAKER PODS w/BRACKETS
Stock RZR roll cages use the 1.75 inch tube. If you have an
aftermarket or custom cage you will find the correct bushings and
mounts included in the box with the pods. Refer to the manual
included with your pods for additional details on mounting and
wiring.
Mount the pod and swivel bracket to the roll cage tube. Once the speakers are on the roll cage tube, you
can gently slide the pod up or down on the tube to determine where your final height will be. Use painter’s
tape to measure and mark a general position so it’s even on both sides. Figures 13-2a and 13-2b show
potential mounting options to try out.
Once the general mounting position is chosen, do not fully tighten the pods
as you may want to do final adjustments for your ear height after the seat
is in position and the system is playing music.
STEP 2 – CONNECT WIRING
Make two (2) crimped speaker wiring connections as indicated in Figure
13-3 for the driver’s side pod. Illumination wiring is optional with accessory
rings. Repeat the two (2) wiring connections for the passenger’s side pod.
STEP 3 – HEAT SHRINK WIRING CONNECTIONS
Use a lighter or heat gun to heat shrink and seal the crimped connections
as shown in Figure 13-4 to ensure no moisture penetration.
Note: Do not zip-tie the wires along the roll cage or gather up excess wire
until the system has been fully tested.
Figure 13-1
Figure 13-2a
Figure 13-2b
SWIVEL STRAIGHT
This position offers
MAXX volume
SWIVEL DOWN
This position will have less
volume to riders in the RZR
● SOLID GREEN - Left Rear S (White Wire)
● GREEN/BLACK - Left Rear Speaker - (Black Wire)
● SOLID PURPLE - Right Rear S (White Wire)
● PURPLE/BLACK - Right Rear Speaker - (Black Wire)
● RED - Illumi (Optional LED Light Ring Required)
● BLACK - Illumination -
Figure 13-3
Figure 13-4
