MB QUART FORMULA FX1.400, Руководство по установке

Страница: 6 / 11

2-Channel Amplifiers
FX2.60
5
OUTPUT INPUT
L
R
6V 0.2V 0dB 9dB 30Hz 150Hz 10Hz 1.2kHz FULL HP LP
LEVEL BASS EQ HIGH PASS LOW PASS X-OVER
POWER PROTECTION
FEATURES:
- 1
Set of RCA inputs
- LEVEL: Variable sensitivity from 0.2V to 6V
- BASS EQ: Adjustable 45Hz bass boost from 0dB to 9dB
- X-OVER: Selects internal crossover functions
- FULL: Bypasses all crossovers for full frequency operation
- LPF: Selects the built in LOW PASS filter, variable from 30Hz to 150Hz
- HPF: Selects the built in HIGH PASS filter, variable from 1 0Hz to 1.2kHz
- POWER LED : Indicates the powered up and turned on condition
- PROTECTION LED : Indicates a high voltage, low voltage, short circuit,
hard clip, over heating or DC fault condition..
- LINE OUTPUT: Full range RCA pass through.
2 Channel Full Range Stereo:
Control checklist:
Interconnect cable checklist:
- Refer to the section “Settings for Best Performance”
- Connect the two inputs of the amplifier to a Radio/CD with quality RCA cables.
Switch setting checklist:
Minimum final loudspeaker impedances:
- 1/2CH X-OVER: FULL
- You can also feed the SAME signal to both left and right inputs via a Y-adapter RCA cable. Mono Operation:
- Connect the mono speaker positive terminal to the RIGHT +, and its negative terminal to LEFT
- as shown.
Here we show how to use the 2 channel amplifiers as a 1 channel unit by taking
advantage of the mono bridging capability of all MB Quart amplifiers.
Switch setting checklist:
Interconnect cable checklist:
- X-OVER: LP/BP
- A MONO signal source is required to bridge channels 1/2, such as would be available
from the mono sub bass output of an active crossover, whether standalone, or built into
Control checklist:
a head unit or equalizer. If you only have 1 set of RCA outputs from your headunit, you
- Refer to the section “Settings for Best Performance”
can simply connect those to the inputs for ch 1/2 and switch the X-OVER to LP/BP. The
Minimum final loudspeaker impedances:
amplifier will auto sum the signal and provide mono output for bridged channels 1/2.
- 4 ohm mono bridged.
Important: Do not be tempted to connect the hot, or positive outputs, from any source
together to obtain a mono signal, as this could very well damage the output stage of
that source.
POWER INPUT
POWER INPUT
GND REM BA
TT+12V
GND REM BA
TT+12V
RIGHT LEFT
RIGHT LEFT
- + - +
- + - +
BRIDGED
BRIDGED
FUSE
FUSE
OUTPUT INPUT
L R
6V 0.2V 0dB 9dB 30Hz 150Hz 10Hz 1.2kHz FULL
HP
LP
LEVEL
BASS EQ HIGH P
ASS LOW P
ASS X-OVER
POWER
PROTECTION
OUTPUT INPUT
L R
6V 0.2V 0dB 9dB 30Hz 150Hz 10Hz 1.2kHz FULL
HP
LP
LEVEL
BASS EQ HIGH P
ASS LOW P
ASS X-OVER
POWER
PROTECTION
MONO LINE INPUT