16
FRONT SPEAKERS
FRONT SPEAKER INSTALLATION (Continued)
This section continues front speaker installation focusing on the driver’s side.
2
3
Remove switches on lower left
of original driver’s side dash
panel by depressing the tabs
on the top and bottom of the
back of switch.
Replace switches in the same
locations within the new MB
Quart driver’s side dash panel
by simply pushing each into its
mounting opening.
If the vehicle has the Smart-
Lok differential control module,
attach to the underside of
the new dash panel with the
original four 8mm screws.
5
6
Ensure the clip retainers and
washers from the original dash
panel have been reinstalled
correctly before proceeding.
Connect driver’s side speaker
to white speaker wiring near
the amplifier harness area.
Red/black wires are for optional
illuminated speaker rings.
Set panel temporarily in place
without attaching any hardware
or clips. Do not yet plug in
switches in case amplifier
adjustments are needed.
Depress
Tabs
8mm
Screws
● SOLID WHITE - Left Front Speaker (+)
● WHITE/BLACK - Left Front Speaker (-)
● RED - Illumi (Optional Grille Required)
● BLACK - Illumination -
Replace
Switches
4
1
DOUBLE CHECK INSTALLATION STEPS TO THIS POINT
Take a few minutes to double check all of the installation steps to this point ensuring the amplifiers,
speakers and wiring has all been connected as shown in these instructions.
PROCEED TO THE NEXT PAGES TO CONFIRM SETTINGS AND BEGIN TESTING THE SYSTEM.
