MB QUART CAN-AM MAVERICK X3, Руководство по установке

Страница: 14 / 24

14
REAR SPEAKER PODS INSTALLATION (Continued)
REAR SPEAKER PODS
Loosen the 5mm Allen screw
on the swivel base to position
driver side pod to preferred
setting. Tighten Allen screw
once final position is achieved.
Make two (2) crimped
speaker wiring connections as
indicated. Illumination wiring is
optional with accessory rings.
14 15
Using high-quality electrical
tape, cover the connections
with the electrical tape to
insulate from moisture and
electrical shorting.
Replace cover panel over roll
cage mounting points with the
original two T-30 Torx screws.
Leave wiring loose until next
step.
Using supplied zip ties, secure
the taped wiring in place on the
roll cage as indicated.
NEXT STEPS - REPEAT INSTALLATION ON PASSENGER SIDE
Repeat the installation steps 6-15 on the passenger side rear speaker
pod. When connecting the speaker wiring, observe the wire colors listed
on the right of this note. Heat shrink and tape up connections.
10 11 12
Use a lighter or heat gun
to heat shrink and seal the
crimped connections to ensure
no moisture penetration.
● SOLID GREEN - S (White Wire)
● GREEN/BLACK - Speaker - (Black Wire)
● RED - Illumi (Optional Grille Required)
● BLACK - Illumination -
5mm ALLEN
13
PASSENGER SIDE REAR SPEAKER WIRING
● SOLID PURPLE - S (White Wire)
● PURPLE/BLACK - Speaker - (Black Wire)
● RED - Illumi (Optional Grille Required)
● BLACK - Illumination -
FOUR-SEAT CAN-AM X3 MODELS - EXTENSION HARNESS
On four-seat Can-Am X3 vehicles, an extension harness
(included in the Stage 5 kit) must be used. Connect the extension
rear speaker harness at the console area near the bus bar where
the rear speaker pigtail was positioned. Route this harness
through the vehicle and past the rear seats. Then, connect the
standard rear speaker harness (with separate left and right side
wiring). Run rear speaker wiring together through into the engine
area and route individually to speaker locations as instructions on
the previous page describe.
From Main Harness
in Center Console
Connect Extension
Harness First
Route Extension
Harness Through
Vehicle
Passenger
Side
Driver
Side
Connect Rear
Speaker
Harness
Route into
Engine Area
Per Instructions
Driver
Side