Instr 9927916
Rev 01 2017-11
Page 6 of 11
INSTALLATION INSTRUCTIONS
1. Shift vehicle transmission into “PARK”. Turn
ignition switch to “OFF” position and remove key.
2. Flip up passenger seat bottom, remove driver’s
seat and underseat storage compartment, then
disconnect black negative (-) cable from battery.
3. Gain access.
a. Remove hood.
b. If installed, remove or open windshield (as
applicable) to gain access to upper dash.
c. Remove upper dash cupholder by removing
two push pin rivets
A
, then sliding cupholder
rearward. Retain rivets. Cupholder will not be
reused.
d. Tilt steering wheel to full down position. Detach
instrument cluster hood by removing two push
pin rivets
B
, then slide hood (with instrument
cluster) rearward. Disconnect instrument
cluster wiring harness. Retain rivets.
e. Open door to upper storage compartment.
Remove four screws
C
from forward wall of
compartment, then remove compartment/door
assembly from dash. Retain screws.
f.
Remove upper dash.
i.
Remove six push pin rivets
D
along
forward edge of dash.
ii. Remove five push pin rivets
E
from LH side
of dash: two at center cupholder, two at
instrument cluster, and one on underside of
dash above cupholder.
