ENGLISH
ENGLISH
ENGLISH
ENGLISH
13) MAINTENANCE
13) MAINTENANCE
13) MAINTENANCE
13) MAINTENANCE
It is essential to check the state of the supply cable and plug periodically.
IN THE EVENT THE SUPPLY CABLE OR PLUG ARE DAMAGED, CALL IN SKILLED
TECHNICAL PERSONNEL TO REPLACE THEM, THIS TO PREVENT ANY RISK.
IN -CERTIFIED APPLIANCES, A SPECIAL TOOL IS REQUIRED TO OPEN THE BASE
PLATE TO GET AT THE CABLE.
It is recommended to use original spare parts only.
In order to assure the lasting efficiency of the appliance, skilled technical personnel must be
called in to perform periodical maintenance, including detailed checks of the state of those
components subject to wear.
The state of the grinding blades must be checked periodically. Keeping the grinding blades in
an excellent state assures high-quality grinding, resulting in greater productivity and limited
overheating.
14) CLEANING THE APPLIANCE
14) CLEANING THE APPLIANCE
14) CLEANING THE APPLIANCE
14) CLEANING THE APPLIANCE
DISCONNECT THE APPLIANCE’S POWER SUPPLY BY UNPLUGGING IT BEFORE
CLEANING. THE APPLIANCE MUST NOT BE CLEANED USING WATER JETS.
Do not install the appliance in rooms where water jets are used for cleaning.
THE APPLIANCE MUST BE CLEANED PERIODICALLY BY SKILLED TECHNICAL
PERSONNEL ONLY.
Use perfectly clean, disinfected cloths or brushes for cleaning.
Do not use abrasive products as these are liable to take the sheen off shiny parts.
Hopper
Hopper
Hopper
Hopper
Wash the hopper once it has been removed from the appliance (unscrewing the relevant
fastening screw), using neutral soap and water, rinse abundantly with lukewarm water and dry
thoroughly. It is advisable to clean the hopper periodically. Once the hopper has been cleaned,
it must be attached to the upper grinding blade holder using the relevant screw.
Grinding system
Grinding system
Grinding system
Grinding system
Remove the safety screw which prevents the adjustment
disk from being removed. Unscrew the adjustment disk by
turning it clockwise. Having removed the upper grinding
blade holder, clean the grinding blades, threads and the
entire grinding system thoroughly using a clean brush and
cloth. To clean the threads of the grinder please use a
small wire brush.
We recommend to check that the threads of the grinder and of the grinding adjustment disk are
clean: to do so screw the adjustment disk anti-clockwise
without the upper blade holder until the end. If the grinding adjustment disk can not turn easily,
than it is necessary to clean again. If the cleaning operations are not done as above the risk is
to damage the threads.
Please check that the grinding adjustment springs are on their place. Having refitted the upper
grinding blade holder in the relevant slot, please lubricate, with grease suitable for food contact,
the threads of the grinding adjustment disk and its underneath surface which touches the
upper grinding blade holder.
Screw the adjustment disk by turning it anticlockwise, put the self-locking screw back in
whichever of the two holes on the disk enables the best adjustment and, having refitted the
hopper and secured, adjust the grinding as required.
11
11
11
11
GRINDING
ADJUSTMENT DISK
UPPER GRINDING
BLADE HOLDER
GRINDING
ADJUSTMENT SPRINGS
