5
５.
Place the splash shield back in its original position and install
the bolt A (2), fastener B (1) and bolt C (1).
Tightening torque
Bolt A
：
0.6
－
0.9 N
･
m {6.2
－
9.1 kgf
･
cm
・
5.3 – 7.9 in
･
lbf }
Bolt C
：
0.8
－
1.2 N
･
m {8.2
－
12.2 kgf
･
cm
・
7.1 – 10.6 in
･
lbf }
６.
Align the mud flap (rear) with the rear bumper and splash shield
installation holes.
７.
Temporarily tighten the kit bolts (3).
８.
Install the mud flap (rear) in the order shown in the figure on the
left while pressing it against the rear bumper.
Tightening torque
Bolt
：
0.8
－
1.2 N
･
m {8.2
－
12.2 kgf
･
cm
・
7.1 – 10.6 in
･
lbf }
１．
Be sure that here are no excessive gaps.
2
．
Be sure that all bolts are securely tightened.
•
Make sure the bolt is tightened securely.
Make sure to tighten to the specified torque. If tightened
outside the specified torque, the mud flap (rear) could be
damaged or fall off.
CAUTION
5
．
MUD FLAP (REAR) PRECAUTIONS
4
．
CONFIRMATION AFTER INSTALLATION
•
If gasoline, engine coolant, or battery fluid adheres to the painted surface of the resin parts, it will cause
discoloration, stains, or paint peeling. Wipe it off with a soft cloth immediately.
•
Don’t drive through an automatic car wash; it may damage the mud flap (rear).
•
Do not use car polish containing wax compounds. Otherwise, the paint could be damaged.
•
If the vehicle height is lowered due to the vehicle being at maximum passenger or cargo capacity,
decrease the vehicle speed when parking on a road shoulder or entering/leaving a road shoulder or bump.
Otherwise, the mud flaps (rear) could be damaged.
CAUTION
•
If there are any gaps, loosen all the bolts and then retighten them in the order of top, middle, and bottom while pressing
the mud flap (rear) against the vehicle.
Bolt A
Bolt C
Fastener B
Splash shield
Splash shield
Tab
Bolt
Mad flap (Rear)
Bolt
①
②
③
Rear bumper
