Page 3 of 4
AS 090-M11357cmc1105RevA
7
Install bottom attachments
8
Post Installation Inspection
A. Close hood and check alignment between hood
cover and front end cover along seam (between
fender and hood). If adjustment is necessary, adjust
the hood cover by adjusting the hood cover straps.
Refer to step 1.
B. If mask should flap due to high speed or wind
conditions, adjust or remove mask completely.
9
Care and Cleaning
A. Always remove mask before washing vehicle.
B. Hand clean mask using mild soap, rinse thoroughly with
clean water and line dry completely. Do not machine dry!
C. Use Mazda Vinyl/Leather Protectant (or equivalent) to
preserve color and finish.
D. WARNING: Running up on curb will damage this product.
Manufacturer will not be responsible for damage to product
due to accident or misuse.
Place in vehicle glove compartment.
A. Attach clips (O) to back edge of facia in fog light and air intake areas. Attach clips (P) and elastics with hooks (Q) to back
edge of bumper facia.
Q
Q
O
O
P
P
P
10x
10x
6
Install air intake attachments
A. Insert pads (L) into slot located between edge of front facia and top edge of grille area. Insert velcro loop (M) into nearby hole
in grille area and attach velcro hook (N) located at underside edge of bumper facia.
N
M
M
L
L
L
3x
4x
