Page 2 of 4
AS 090-M11356cmc1105RevA
2
Remove wheel well fasteners
A. Using stubby phillips screwdriver, remove five plastic
fasteners along front edge of both front wheel wells.
A. In both front wheel wells, lift wheel well liner to reveal holes.
B. Slip u-nuts (C) over top two and bottom two holes in metal edge,
making sure that holes are aligned.
C. Release liner to its original position. Using a stubby phillips
screwdriver, install washer (D) and snap head screws (E) into top
two and bottom two holes in each wheel well. Reinstall
original fastener into unoccupied middle hole.
3
Install wheel well hardware
C
C
D
D
E
E
E
4
Install upper attachments
A. With hood open, lay front end cover over
front of vehicle. On both sides of vehicle,
slide pockets (F) over front corners
of fenders. Care should be taken
to prevent ripping of pockets (F).
B. Attach clips (G) to edge of fender
rails.
C. On both sides of vehicle, insert
pads (H) in slot under headlights.
D. Attach clips (J) to back inside
edge of metal at center of vehicle
under hood.
H
H
F
J
G
F
G
