Maytag YMHWE201 Series, Инструкция по использованию и уходу

Страница: 14 / 48

14
TRANSPORTING YOUR WASHER
1. Shut off both water faucets. Disconnect and drain water
inlet hoses.
2.
If washer will be moved during freezing weather, follow
WINTER STORAGE CARE directions before moving.
3. Disconnect drain hose from drain system and from back
of washer.
4.
Unplug power cord.
5. Place inlet hoses and drain hose inside washer basket.
6.
Bundle power cord with a rubber band or cable tie to
keep it from hanging onto the ground.
IMPORTANT: Call for service to install transport bolts.
Washer must be moved with transport bolts and in the
upright position. To avoid structural damage to your
washer, it must be properly set up for relocation by a
certified technician.
REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use, vacation, winter storage,
or moving:
1. Refer to Installation Instructions to locate, level, and
connect washer.
2.
Before using again, run washer through the following
recommended procedure:
To use washer again:
1.
Flush water pipes and hoses. Reconnect water inlet
hoses. Turn on both water faucets.
2. Plug in washer or reconnect power.
3.
Run washer through NORMAL cycle to clean washer
and remove antifreeze, if used. Use only HE detergent.
Use half the manufacturer’s recommended amount for
a medium-size load.
Operate your washer only when you are home. If moving,
or not using your washer for a period of time, follow these
steps:
1.
Unplug or disconnect power to washer.
2. Turn off water supply to washer to avoid flooding due
to water pressure surges.
WINTER STORAGE CARE
IMPORTANT:
To avoid damage, install and store washer
where it will not freeze. Because some water may stay in
hoses, freezing can damage washer. If storing or moving
during freezing weather, winterize your washer.
To winterize washer:
1.
Shut off both water faucets; disconnect and drain water
inlet hoses.
2. Put 1 qt. (1 L) of R.V.-type antifreeze in basket and
run washer on RINSE/DRAIN & SPIN cycle for about
30 seconds to mix antifreeze and remaining water.
3.
Unplug washer or disconnect power.
IMPORTANT: To reduce risk of hose failure, replace inlet
hoses every five years and periodically inspect for kinks,
cuts, wear, or water leaks.
HELPFUL TIP:
When replacing your inlet hoses, mark
replacement date on label with a permanent marker.
NON-USE AND VACATION CARE
CLEANING THE DISPENSER cont.
4. Wash dispenser and cover panel in warm, soapy water,
using a mild detergent.
5.
Rinse with warm water.
6. Air dry or wipe with a clean towel. Replace the insert.
7.
Align edges of dispenser with guides in washer, then
slide dispenser back into slot.
IMPORTANT:
Dispenser is not dishwasher safe.