Maytag WED97HEXL, Руководство по установке

Страница: 3 / 24

3
INSTALLATION REQUIREMENTS
ToolS AnD PARTS
Gather the required tools and parts before starting installation.
Tools needed:
Flat-blade screwdriver #2 Phillips screwdriver
Adjustable wrench that
opens to 1" (25mm) or
hex-head socket wrench
Wire stripper (direct wire
installations)
Tin snips (new vent
installations)
1/4" nut driver
(recommended)
Utility knife
Level
Tape measure
Pliers
Parts supplied:
Caulking gun and
compound (for installing
new exhaust vent)
Leveling legs (4) “Y” connector
Rubber washer
Short inlet hose Long inlet hose
Parts needed:
(Not supplied with dryer)
Parts package is located in dryer drum. Check that all parts
are included.
noTE:
Do not use leveling legs supplied if installing on a
pedestal.
If using a power supply cord:
Use a UL listed power supply cord kit marked for use with
clothes dryers. The kit should contain:
A UL listed 30-amp power supply cord, rated 120/240 volt
■
minimum. The cord should be type SRD or SRDT and be
at least 4 ft. (1.22 m) long. The wires that connect to
the dryer must end in ring terminals or spade terminals
with upturned ends.
A UL listed strain relief.
■
Min. 8" long Torx ® T25
screwdriver
(for door reversal only)
® TORX is a registered trademark of Acument Intellectual Properties, LLC.
optional Equipment:
(Not supplied with dryer)
Refer to your Use and Care Guide for information about
accessories available for your dryer.
Vent clamps
■
Vent elbows and ductwork
■
Additional parts may be required, depending in your installation.
Check local codes. Check existing electrical supply and venting.
See “Electrical Requirements” and “Venting Requirements”
before purchasing parts.