9
8.
Prepare Range Hood Vents
and Mounting Tabs
■
Install Strain Relief
Install a UL Listed/CSA Approved
1
/
2
" (13 mm)
strain relief (A).
■
Mounting Tabs
Start a #8-18 x
5
/
8
" (4.2 x 16 mm) truss-head screw into
the mounting tab (D) on each side of the range hood
as shown in the inset. Insert the screws approximately
2 turns into the mounting tab holes.
■
7" (17.8 cm) Round Vent Installations
Remove both top knockouts (B and C).
9.
Attach Vent Damper or Transition
7" (17.8 cm) Round Vent Mounting Plate
■
Using (2) short Phillips head screws, install the 7" (17.8 cm)
round vent mounting plate over the vent knockouts
removed in Step 8. Position the wide flange (C) to the front.
NOTE:
An optional 7" (17.8 cm) round damper (A),
Part Number W10355451 is available as an accessory.
For information on ordering, see the “Assistance
or Service” section.
■
If installing the optional round damper, position
it over the round vent mounting plate.
10.
Mount Range Hood
■
Lift the range hood into place, positioning the rear slots
over the mounting brackets.
■
Using a Phillips screwdriver, push on the screws that
are started into the top mounting tabs, and bend the
tabs against the cabinet side walls. Attach the screws
to the cabinet side walls.
IMPORTANT:
Do not overtighten the screws.
■
For direct wire installations, run the home power supply
cable according to the National Electric Code or CSA
standards and local codes and ordinances. There must
be enough wiring from the fused disconnect (or circuit
breaker) box to make the connection in the range hood
electrical terminal box.
■
Tighten the strain relief screws.
NOTE:
Do not reconnect power until the installation
is complete.
OPTIONAL:
If you prefer, bend the rear tabs against
the rear of the range hood and attach to the wall using
#8-18 x
5
/
8
" (4.2 x 16 mm) truss-head screws.
11.
Connect Vent System
■
Connect the ventwork to the range hood.
■
Seal joints with vent clamps or duct tape to make
secure and airtight.
■
Check that the back draft dampers work properly.
A
B
C
x2
D
A
B
C
