10
For most concerns, try these
first:
•
Check if oven controls have been prop-
erly set.
•
Check to be sure plug is securely inserted
into receptacle.
•
Check or re-set circuit breaker. Check or
replace fuse.
•
Check power supply.
Part or all of appliance does
not work.
•
Check if surface and/or oven controls
have been properly set. See pgs. 3 & 6.
Baking results not as expected
or differ from previous oven.
•
Make sure the oven vent has not been
blocked. See pg. 7 for location.
•
Check to make sure range is level.
•
Temperatures often vary between a new
oven and an old one. As ovens age, the
oven temperature often “drifts” and may
become hotter or cooler.
•
Check rack positions. See pg. 7.
•
See
“Cooking Made Simple”
for more
information on bakeware and baking.
Food not broiling properly or
smokes excessively.
•
Check oven rack positions. Food may be
too close to element.
•
Broil element was not preheated.
•
Aluminum foil was incorrectly used. Never
line the broiler insert with foil.
•
Oven door was closed during broiling.
Leave the door open to the first stop posi-
tion (about 4 inches).
•
Trim fat from meat before broiling.
•
A soiled broiler pan was used.
Moisture collects in oven or on
oven window.
•
This is normal when cooking foods high in
moisture.
•
Excessive moisture was used when clean-
ing the window.
There is a strong odor or light
smoke when oven is turned on.
•
This is normal for a new range and will
disappear after a few uses.
•
Turning on a ventilation fan will help
remove the smoke and/or odor.
•
There are excessive food soils on the oven
bottom.
“F” plus a number appears in
the display.
•
This is called a fault code. If a fault code
appears in the display and beeps sound,
press the
Cancel
pad. If the fault code and
beeps continue, disconnect power to the
appliance. Wait a few minutes, then re-
connect power. If fault code and beeps
still continue, disconnect power to the
appliance and call an authorized servicer.
Before You Call for Service
Oven Light
Leveling Legs
CAUTION:
•
Be sure the anti-tip bracket se-
cures one of the rear leveling legs
to the floor to prevent the range
from accidentally tipping.
The range should be leveled
when installed. If the range is
not level, turn the plastic lev-
eling legs, located at each
corner of the range,
until range is
level.
CAUTIONS:
•
Disconnect power to range be-
fore replacing light bulb.
•
Use a dry potholder to prevent
possible harm to hands when
replacing bulb.
•
Be sure bulb is cool before
touching bulb.
•
Do not touch hot bulb with a
damp cloth as this may cause
the bulb to break.
ANTI-TIP BRACKET
LEVELING LEG
To replace light bulb:
1.
Remove light bulb.
2.
Replace with a 40 watt appliance bulb.
3.
Reconnect power to range. Reset clock.
CIRCUIT BREAKER SWITCH
Convenience
Outlet
(C
ANADIAN
MODELS
ONLY
)
The convenience outlet is located on the
lower left side of the backguard. Be sure
appliance cords do not rest on or near the
surface element. If the surface element is
turned on, the cord and outlet will be
damaged.
The convenience outlet circuit breaker
may trip if the small appliance plugged
into it exceeds 10 amps. To reset the cir-
cuit breaker, press the switch located on
the lower edge of the backguard.
