!
WARNING
To avoid risk of electrical shock that can cause death or severe personal injury, disconnect unit from power before
servicing unless tests require power. Discharge capacitors through a 10,000-ohm resistor before handling. Wires
removed during disassembly must be replaced on correct terminals to ensure proper grounding and polarization.
16025860
A - 4
©2005 Maytag Services
NOTE: New fill cups are molded with two break-out slots
for a fill tube. This is done so that the same cup can
be used in several applications.
To install a new fill cup:
a. Disassemble ice maker per instructions above.
b. Using ordinary pliers on new fill cup, break out fill
slot required by your application.
c. Mount new fill cup and reassemble ice maker.
Break out appropriate tab
to make slot for fill tube
Water Fill Adjustment
Turning the water level adjustment screw moves the
contact point in relationship with the contact ring
segment upon which it rides. Because the contact ring is
tapered, movement of the contact point causes variation
Module Anchor screws (3)
Mold Anchor screws (2)
Mold & Heater assembly
Support assembly
Stripper
Fill Cup
Ejector
Ice Maker bracket
Screw
Thermal Fuse clip
Thermostat Retainer clip
Thermostat
Module assembly
(not replaceable,
order new ice maker)
(not replaceable,
order new ice maker)
(not replaceable,
order new ice maker)
(not replaceable,
order new ice maker)
Shut-Off Arm
assembly
