Maysun Solar MS M-36 Series, Руководство по установке

Страница: 9 / 17

9
www. maysunsolar. com
B. Mounting with Clamps
Maysun Solar has tested its modules with a number of clamps from different manufacturers and recommends the use of
clamps that have an EPDM or similar insulating washer, fixing bolt ofat least M6.
The clamp must overlap the module frame by at least 7mm(0.28in) but no more than
10mm(0.39in). Use at minimum 4 clamps to fix modules on the mounting rails.
Modules clamps should not come into contact with the front glass and must not deform the frame.
Be sure to avoid shadowing effects from the module clamps.
The module frame is not to be modified under any circumstances.
When choosing this type of clamp-mounting method, use at least four clamps on each module, two clamps should
be attached on each long side ofthe module ( for portrait orientation) or each short sides ofthe module (for landscape
orientation) . Depending on local wind and snow loads, additional clamps may be required to ensure that modules can
bear the load.
End Clamp installation Middle Clamp installation
±2400Pa Load +5400Pa/-2400Pa Load
Mounting rail
4-
φ
9*12 installation hole
Figure 2.
PV module installed with clamp fitting method