5
•
The default pressure will be set according to the chosen user mode setting.
•
Note:
The display will only show inflation pressures when the pump is connected to a valve.
•
Press the ‘SET’ button to select the unit of measure (psi, bar, kPa, kg/cm2).
•
Press the “
-
“ or “+” button to choose the desired value. Holding the “
-
“ or “+” button will accelerate the numerical
change.
•
Connect the adaptor into the valve of the item you are inflating.
•
Press the ‘POWER’ button to start the air pump.
•
When the item to be inflated has reached the preset value the unit will automatically turn off.
•
To stop the pump at any time press the On/Off button again.
•
You may notice the actual pressure reading may drop after a couple of seconds, this is normal.
•
In automatic shut off mode the air pump will inflate approx 1.5 PSI over the pre set value before it cuts out to compensate
for pressure fluctuations during the inflation process.
•
Note:
The user mode and pre set pressure value will be saved when the device is turned off and will be automatically
restored when it is next used.
•
The air pump can be used as a power bank to charge anything that requires a 5VDC supply, such as phones, tablets and
many other portable devices
•
To charge a device insert a USB cable (not included) into the 5V/1.5A USB outlet.
•
Connect to your device.
•
The c
harging status can be confirmed when ‘’USB”
is displayed.
•
If the pressure value is not 0.0 when the device disconnected from a valve the pressure requires calibrating.
•
Press the PRESET (+) and PRESET (-) simultaneously for 2 seconds. A change of display denotes the calibration process.
The pressure value should be re-set at 0.0.
SETTING THE AUTOMATIC SHUT OFF PRESSURE
USING THE POWER BANK
Pressure Calibration
