4
•
Only ever recharge the battery via a 5VDC USB supply; note that charging via a PC or laptop may extend charge times.
•
Connect the type C USB plug into the USB input charging socket.
•
Connect the type A plug to a 5V 1A supply.
•
The battery charging status can be confirmed when ‘CHG’ is displayed. The battery level indicator
shows the charging
status.
•
After 10 seconds of no operation during charging the display will automatically turn off.
•
The device cannot be used when charging.
•
Once all 4 battery indicator lights are permanently illuminated the charge process is complete.
•
Fully charge the battery at least once every 3 months to ensure the condition of the battery is maintained.
•
Before use, ensure the device is sufficently charged and check the manufacturer’s recommended pressure for the item
you are inflating.
•
Ensure the air hose is securely screwed into the pump.
•
Select the appropriate adaptor for the item you are inflating and screw into the air chuck.
•
Connect the adaptor into the valve of the item you are inflating.
•
To turn on the air pump hold the
‘POWER’
button for 3 seconds.
•
The current pressure of the item being inflated will be displayed, unit of measure can be changed (psi, bar, kPa, kg/cm2)
by pressing the ‘SET’ button.
•
To switch between 5 user modes
press the ‘MODE’ button. Each mode
is pre set at the below default pressures:
User Mode
Default Pressure
Pressure Range
35PSI
0-65PSI
40PSI
0-55PSI
38PSI
0-150PSI
8PSI
0-150PSI
100PSI
0-150PSI
•
Press the
‘POWER’ button to start the air pump.
•
The air pump will run continuously until the ‘POWER’
button is pressed again.
•
To activate the LED light press and hold the ‘SET’ button
.
•
To turn off the air pump hold the power button for 3 seconds. Note
–
it will automatically shut down after 3 minutes of
no activity.
QUICK START
CHARGING
