INSTALLATION AND CARE GUIDE
www.maykke.com
INSTALLATION AND CARE GUIDE
SUPPLIED ACCESSORIES:
INSTALLATION OF HOUSING(Refer to Figure 1)
INSTALLING THE LOUVER(Refer to Figure 1)
Screw
(ST4X30)
Grille
Suspension
bracket
4
4
Rough Opening:23.4cm(9 1/4”) l x 23.4cm(9 1/4”) w
Housing Size :23cm(9”) l x 23cm(9”) w x 20cm(7 3/4”) h
The louver can be installed when the finished ceiling has been completed. Place the
louver’s torsion spring mounting clips into the slot holes on both sides of the fan unit and
press it closed.
1. Remove the louver from the unit before the mounting.
3. Loosely attach one end of a hanger bar to the joist by
inserting a screw through the eyelet at the end of the bar
into the wooden joist.
4. Attach the second hanger bar to the same joist.
6. For the louver to fit properly, the flange of the hous-
ing must be leveled to the soffit level of the ceiling.
5. Level the fan housing and attach the third and fourth
hanger bar ends to the next joist. Adjust and tighten the
screws.
2. Install sliding hanger bars onto the fan housing by ins-
erting the bars into the hanger bar support guide rail.
REV.10152018
Figure 1
