![MAY FILIUS Скачать руководство пользователя страница 2](http://html1.mh-extra.com/html/may/filius/filius_operating-instructions-manual_1747085002.webp)
Non- observation of operating instructions can result in personal injuries or damage to property.
Please note that if these instructions are not observed, the manufacturer cannot assume any
liability or guarantee.
• Always follow the safety regulations.
• Should you not understand any part of these operating instructions, please contact your
MAY dealer.
Wind can damage your parasol. No guarantee possible.
• Always completely open or close the parasol. Never leave it merely half-opened, as it is
then not fully stable.
• Immediately close the parasol whenever wind rises.
• If parasols are erected in an exposed location (e.g. in upcurrents, on sloping ground,
in wind corridors, etc.) the weight of the base must be increased.
Assembling and erecting the parasol
1. Fasten the upper anchor tube to the lower tube with socket head screw.
A falling parasol can cause serious or even fatal injury.
If, during assembly, the anchor tube slips away, it will be impossible to hold onto the parasol.
It will fall down and possibly cause a serious accident.
• Make sure all anchor tube screws and hinges function properly
• Tighten the M16 socket head screw with a torque of 210 Nm.
Screws that are not tightened correctly will work loose.
If screws are not tightened firmly enough, there will not be sufficient tensile force to trigger
self-locking. If the screws are tightened too firmly and over-stressed, the screw connection
may slacken.
• Tighten the screw manually using the enclosed hex key and extension. Exert as much force
as possible. With the enclosed tools there is virtually no risk of over-stressing.
• The correct torque for a torque wrench is 210 Nm.
Caution
Warning
Danger
Danger
2. Loosen the clamp there is sufficient clearance inside the anchor tube for the centre pole to be
inserted vertically.
Assembly: Unpacking the parasol
1. Remove bottom end cap of the front part of the cardboard sleeve. Use a cordless screwdriver with
a T30 bit to remove the torx screws.
Caution
If the parasol is improperly withdrawn from the cardboard tube, the canopy fabric may
be damaged.
When the parasol is withdrawn, the metal brackets that fasten the tube caps can tear the fabric.
• Remove all metal brackets from either end of the protective tube before withdrawing the
parasol.
ref. 1.
ref. 2.
upper end cap
upper supporting cap
lower supporting cap
lower end cap
page 2 of 16 Deutsch /
English
/ Français
Stand 36-2428
Stand 36-2428
Deutsch /
English
/ Français
page 3 of 16