19
ENG
Device selection (MACHINE)
The version of your training device is stored here. The correct version “300” has already been set in the factory.
Please do not change this information, otherwise the parameters will no longer match and the training values
may be displayed incorrectly.
Step 1:
Press the MODE key. The current setting of the device version will be shown in the display.
Step 2:
Select the version “300” by pressing the
keys.
Step 3:
Confirm your selection by pressing the MODE key.
Exiting the Service Menu (EXIT)
To exit the service menu, select the menu item “EXIT” by pressing the
keys.
Confirm your selection by pressing the MODE key.
Error message
In the event of an error, the corresponding error message will appear in the display
Error message E1
Error description: The cockpit is not receiving any data.
Measures:
1. Disconnect the mains adapter from the socket for approx. 10 seconds.
2. Check if the cockpit cable has come loose from the cockpit or if it is completely disconnected.
→ Connect the cockpit cable to the cockpit.
3. Check if the cockpit is damaged.
→ Contact the MAXXUS Service Department.
Error Message E8
Error description: FLASH malfunction (error of the EEPROM IC).
Measures:
1. Disconnect the mains adapter from the mains socket for approx. 2 minutes and then switch the cockpit
back on again.
If the error message appears again, please contact the MAXXUS Service Department.
Error Message E81
Error description: Malfunction of the resistance setting.
Measures:
Disconnect the mains adapter from the mains socket for approx. 2 minutes and then switch the cockpit back on
again.
If the error message appears again, please contact the MAXXUS Service Department.
Error Message E82
Error description: Calibration malfunction
Measures.
1. Disconnect the mains adapter from the mains socket for approx. 2 minutes and then switch the cockpit
back on again.
If the error message appears again, please contact the MAXXUS Service Department.
Cockpit
