18
c.
To set the temperature
, press the
temperature
buttons to increase or decrease the
temperature to the desired temperature. If the “Heat" light is on, the temperature setting will
increase one degree every time the button is pressed. If pressed for three seconds, the setting
will increase quickly. Decrease the temperature in the same manner by pressing the
button. After the sauna reaches the desired temperature, the “Heat” light will turn off.
d.
Press the button to turn the light ON and OFF. If you want to use the
Color Light Therapy
System
:
1.
While the interior light is ON, press and hold down the button for 2 seconds.
You will notice “2n” in the LED display. This indicates you are in the “light” mode. If
you do not press any button
s for approximately 15 seconds, the “2n” will change back
to the Timer mode.
1.
While the “2n” is displayed,
you can now turn the exterior light ON/OFF by pressing the
button in the section of the control panel.
2.
You can also turn the interior light ON/OFF by pressing the
button in the
section of the control panel.
3.
While the interior light is on and the “2n” is still displayed in the LED display, you can
press the button to scroll through the different colors within the Color Light
Therapy System. You will notice that you have two selections for “white”:
A.
The first selection for “white” will allow the colors to go through a sequence of
the different shades of colors.
B.
The second selection for “white” will continue to display the white light.
5.
To return back to the Timer mode, press the button.
e.
You can operate the sauna with the ceiling vent in the open or closed position based on personal
preference.
f.
After your sauna session is over, you can turn the control panel off by pressing the ON/OFF button.
You can unplug the sauna cord to protect the electronics from power surges.
g.
To set the time
, press the
buttons. Press
or
buttons to set the timer from 5 to
60 minutes. If pressed for three seconds, the timer will increase/decrease quickly. When the time
expires, the timer will buzz and the sauna will shut off automatically. Please note that the light will
have to be physically turned OFF if it is ON. To extend the sauna session, reset the timer again by
pressing the .
h.
The Fahrenheit and Centigrade display
can be switched by pressing and holding the
TEMPERATURE
side buttons
and
at the same time and then pressing the .
i.
The Bluetooth function
is built into the Control Panel. For the Bluetooth function, you first will need
to pair your device with the sauna room. Open your device’s Settings Menu and then locate and
open Bluetooth. You will find “
BT-AUDIO”
or
“BT-SAUNA”
. Now you can pair your device. Once
pairing is successful, your device will be connected. You will control the volume and choose the
music on your device.
