17
Operating the Sauna
NOTE: Please check and confirm that the connections to the POWER SUPPLY,
HEAT EMITTERS, and TEMPERATURE SENSOR are connected properly. The
power supply voltage and frequency must match the requested voltage and
frequency of the sauna (120VAC 15AMP Dedicated Circuit or 120VAC 20AMP
Dedicated Circuit). This is a residential /semi-commercial appliance. For every (3)
hours ON, the unit must have (1) hour OFF.
Since many materials absorb the infrared rays, minimal clothing is recommended
for maximum effect. The infrared sauna emitters are designed to heat you and not
necessarily the air inside the sauna. It is not a hot box like a traditional sauna. The
temperature gauge is a guide for your safety. It is recommended that you drink
water before, during, and after sauna use to prevent dehydration since body fluids
will be lost through perspiration. It is not recommended to shower after use since
the pores in your skin will be open and could possibly absorb anything in the water.
Control Panel
1. Precautions
a.
Please make sure your wall outlet meets the specifications required. Failure to meet the
requirements may cause safety risks.
b.
Set the temperature and time to a comfortable level. The average used temperature range is
between 118ºF – 122ºF. The average sauna session is approximately 20 – 30 minutes.
It is
recommended that you pre-heat the sauna room to the desired temperature before
entering.
Note: If the ambient temperature is below 72
℉
, the sauna will take longer to pre-
heat. It is not recommended to use the sauna in an environment with an ambient temperature
below 60
℉
.
c.
Drink water prior to, during, and after your sauna session to replenish body fluids.
d.
After 2 hours of continuous use, the sauna needs to be shut down for one hour.
e.
To avoid burns, do not touch the heating element.
2. Operating The Sauna
a.
Review the electrical label on the sauna and then plug the sauna into the proper wall outlet. No other
appliance can be operated on the same electrical breaker as the sauna when the sauna is in use.
Proceed in turning on the sauna room using the ON/OFF button to activate the sauna.
b.
The sauna should be
unplugged
when not in use. If you do not have access to the plug, it is
recommended to use a heavy duty surge protector.
