Maxxus 6.4, Инструкция по установке и эксплуатации

Страница: 9 / 32

Clip
Safety Key
9
ENG
Mains Cable
Safety Key
Mains Cable
Connect the mains plug on the mains cable to an electrical sock-
et.
This device is only to be connected to an earthed socket installed
by a qualified electrician. Do not use a socket strip to connect
the treadmill belt. If an extension cable is required, then it must
comply with DIN standards, VDE regulations and guidelines,
technical rules issued by other European Union member states or
other states which are party to the Agreement on the European
Economic Area.
Main Switch
The main switch is located next to the mains connection on the
front of the treadmill. Use this switch to turn the treadmill on and
off.
Switch position “I” = treadmill turned on.
Main Switch position “0” = treadmill turned off
Fault-Current Button Switch
Main Switch
Fault-Current Switch (depending on the model)
There is a fault-current button-switch next to the main switch on the front of the motor cover to prevent the treadmill from
being damaged by electrical surges in the network. This button-switch is triggered off by if a surge in the electrical supply
occurs and acts as a circuit breaker. In this case the treadmill will be completely switched off. If this occurs, switch off the
treadmill at the main switch, and pull the mains cable out of the socket with the plug. Press the button on the fault-current
switch back in. Re-connect the mains cable with the plug and switch the treadmill back on at the main switch.
Fuse (depending on the model)
There fuse next to the main switch on the front of the motor cover to prevent the treadmill from being damaged by electrical
surges which can occur in the network. In this case the treadmill will be completely switched off. If this occurs, switch off the
treadmill at the main switch, and pull the mains cable out of the socket with the plug. Check the fuse and replace it if neces-
sary. Re-connect the mains cable with the plug and switch the treadmill back on at the main switch.
Safety Key
The treadmill will only operate if the safety key is correctly in
contact with contact point in the cockpit. The treadmill will stop
automatically if the safety key is no longer in contact.
Before each training session make sure to attach the safety key
to your clothing with the clip.
If you want to stop the treadmill quickly, cannot keep up with the
speed, or any other emergency arises, pull the string to remove
the safety key out of the cockpit. If the safety key is connected to
your clothing it will automatically be pulled out of the cockpit if you
fall. It is therefore vital to make sure that the clip is securely fas-
tened to your clothing and cannot somehow be pulled off. Adjust
the length of the string to hang down loosely during training.
It is not possible to operate the treadmill without the safety key
being correctly inserted. Always remove the safety key when your
treadmill is not in use to ensure that it cannot be used by any
other third party, for example by children, without your permission
or unsupervised.
The treadmill will stop automatically if the safety key is pulled out
of the cockpit during training. The incline will remain in the adjust-
ed position and can only be lowered after the safety key has been
re-connected.