EN
16
CARE AND DESCALING
Please Note!
■
Regularly descale the device.
■
The device is
not
dishwasher-safe!
■
Do not use any sharp or abrasive
cleaning agents or cleaning pads to
clean the device. These may damage
the surfaces.
1. Completely empty the kettle (
9
).
2. Rinse out the kettle with a little mild
detergent and clear water.
Make sure
that no water gets into the contacts
on the bottom of the kettle! Do not
immerse the kettle in water!
This
could cause a short circuit.
3. Dry everything thoroughly.
4. Wipe down the base station (
7
) with a
dry cloth if necessary.
The kettle can be stored on the
base station when it is not being
used. In this case, pull the mains
plug from the plug socket as the
kettle is in stand-by mode while it
is connected to the mains power.
Descaling
The device should regularly be descaled.
Use a standard descaling agent for kettles
for descaling.
1. Pour a mixture of water and descaling
agent into the kettle (
9
) and switch it
on. To do this, follow the instructions
in the “Set-Up and Connection” and
“Use” chapters.
Consult the instructions for using
the descaling agent with regard
to the ratio of water to descaling
agent.
2. Empty the kettle after boiling. Do not
drink this water!
3. Fill the kettle with drinking water and
bring it to the boil at least once more
to remove any residues of the descal-
ing agent. Do not drink this water!
STORAGE
•
Disconnect the device from the mains
power when it is not going to be used
for a prolonged period. Clean the de-
vice again if necessary (see the “Care
and Descaling” chapter) and let it dry
completely.
•
Store the device and all accessories
in a dry, clean, frost-free place that
is protected from direct sunlight and
cannot be accessed by children or
animals.
TROUBLESHOOTING
If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps below, contact
the customer service department.
Do not attempt to repair an elec-
trical device yourself!
The device does not work.
The mains plug is not inserted in the plug
socket correctly.
►
Correct the fit of the mains plug.
The plug socket is defective.
►
Try another plug socket.
There is no mains voltage.
►
Check the fuse of the mains connec-
tion.
The On / Off switch (
6
) has not been
pressed.
►
Switch on the device with the
On / Off switch.
09753_Inlay_DE-EN-FR-NL_A5_V1.indb 16
09753_Inlay_DE-EN-FR-NL_A5_V1.indb 16
01.07.2020 08:54:01
01.07.2020 08:54:01
