46
5. El sitio debe estar firme y nivelado. Una posición insegura puede provocar ruidos y
vibraciones:
(a) El ruido puede aumentar si el piso no es sólido.
(b) Si desea colocarlo sobre una alfombra, coloque un plato debajo del aparato
para disolver la emisión de calor.
6. Asegúrese de que las patas ajustables estén seguras e incline el aparato
ligeramente hacia atrás para mantener las puertas cerradas.
INSTRUCCIONES DE FUNCIONAMIENTO
Colocación de alimentos
1. Siempre debe haber algo de espacio entre los objetos en
el interior para que circule el aire.
2. Los alimentos deben conservarse en envases cerrados para
evitar que se sequen o huelan.
3. Los alimentos calientes deben enfriarse antes de colocarlos en
el aparato; de lo contrario, la temperatura interna y el consumo
de electricidad aumentarán.
4. Reducir la frecuencia de apertura de la puerta para reducir
de manera eficiente el consumo electrónico.
ADVERTENCIA
No utilice ningún equipo electrónico en la unidad.
Instrucciones de uso
La temperatura del frigorífico se puede controlar manualmente con el botón giratorio.
Sin embargo, el número del botón no indica directamente la temperatura. Cuanto
mayor sea el número, menor será la temperatura interior. 0 significa apagado.
Coloque la perilla en la posición 4 si el refrigerador está en uso normal, en la posición
4-7 si desea una temperatura interna más baja; en la posición 1-4, por otro lado, si se
desea una temperatura más alta.
EMBALAJE Y MUDANZA
1. Desembalar, volver a embalar y transportar. Al desembalar o volver
a embalar el producto, recuerde la posición de cada accesorio
del aparato y compruébelo detenidamente antes
de transportarlo.
2. No levante ni tire de la puerta o la manija de la puerta durante
el transporte.
3. Al moverse, la unidad no debe inclinarse más de 45 grados
(el ángulo desde la dirección vertical). Evite vibraciones e impactos fuertes.
MANTENIMIENTO
El aparato debe mantenerse y limpiarse con regularidad. Por su seguridad, desenchu-
fe el aparato antes de limpiarlo.
1. Mantenimiento interior.
Limpiar el interior del aparato con agua limpia o un detergente neutro. Frote la
unidad con agua limpia y límpiela con un paño seco.
2. Mantenimiento de la junta de la puerta.
Las juntas de la puerta pueden dañarse fácilmente si se ensucian con manchas
como aceite, salsa, etc.
3. Mantenimiento del exterior.
Limpie el polvo con un paño seco, si es necesario límpielo con un detergente
neutro.
5
4
INSTRUCTION FOR USAGE
Unpack , repack and carry
Please memorize the position of each accessory of the appliance
when unpack it, repack the product and check it carefully before
transportation.
Do not lift or pull the door or the door handle during transportation.
When moving, the appliance can not be sloped over 45 degrees
(the angle to the vertical direction). Please avoid strong vibration
and hit.
PACKING AND MOVING
1.
2.
3.
The appliance should be maintained and cleaned frequently. For your safety,do
please pull the plug out of the socket before the cleaning.
Interior maintenance
Clean the interior of the appliance with clean water or neutral abluent.Scour it with
clean water and wipe it with a piece of dry cloth.
Maintenance of door gasket
It is easy to damage if the door gaskets are polluted by the stain like oil, sauce and
etc., so it is better to clean them carefully.
Outer maintenance
Wipe the dusty with a piece of dry cloth ,clean it with neutral abluentif necessary.
MAINTENANCE
1.
2.
3.
Do not use any electronic equipment inside the appliance.
Warning
The refrigerator should be located in a completely flat surface , Leave 5~10 cm
between each side of the appliance and the wall, and leave 30 cm between the top
of the appliance and the ceiling.
Choose a location which is not exposed to sunlight ,
high temperature or humid , as humidity maycause stain.
Pulled out the bottom panel before installation.
The appliance can be adjusted by rolling its two legs in
front the bottom when it is unstable. Rolling in clockwise
can rise up the machine.
The location should be firm and flat. An un-securely
position may cause noise and libration:
(a)The noise may be increased if the floor is not firm.
(b) Put a sheet under the appliance for solving the heat
emission if you need to locate it onto a carpet.
Make sure the adjustable legs are clung to the floor,
and set the appliance slope backward slightly for keeping the doors closed tightly.
PLACEMENT OF FOOD
INSTALLATION INSTRUCTIONS
OPERATION INSTRUCTIONS
1.
2.
3.
4.
5.
6.
There should always be some space between items inside for air circulation.
Food should be
to avoid becoming
dry or with odour.
kept in sealed package
Hot food should be cooled down before placing into the
appliance. Otherwise, interior temperature and electronic
consumption will increase.
Reduce the frequency of door opening can efficiently low
down the electronic consumption.
1.
2.
3.
4.
The temperature of refrigerator can be controlled manually by the
knob. However, the number shown on the knob does not directly
represent the temperature. Instead, the larger the number is, the lower
the interior temperature will be. 0 stands for off. Turn the knob to state
4 when it is normal used, turn it to the state during 4-7 if a lower interior
temperature is required; contrarily, to the state during 4-1, when a
higher one is needed.
5
4
INSTRUCTION FOR USAGE
Unpack , repack and carry
Please memorize the position of each accessory of the appliance
when unpack it, repack the product and check it carefully before
transportation.
Do not lift or pull the door or the door handle during transportation.
When moving, the appliance can not be sloped over 45 degrees
(the angle to the vertical direction). Please avoid strong vibration
and hit.
PACKING AND MOVING
1.
2.
3.
The appliance should be maintained and cleaned frequently. For your safety,do
please pull the plug out of the socket before the cleaning.
Interior maintenance
Clean the interior of the appliance with clean water or neutral abluent.Scour it with
clean water and wipe it with a piece of dry cloth.
Maintenance of door gasket
It is easy to damage if the door gaskets are polluted by the stain like oil, sauce and
etc., so it is better to clean them carefully.
Outer maintenance
Wipe the dusty with a piece of dry cloth ,clean it with neutral abluentif necessary.
MAINTENANCE
1.
2.
3.
Do not use any electronic equipment inside the appliance.
Warning
The refrigerator should be located in a completely flat surface , Leave 5~10 cm
between each side of the appliance and the wall, and leave 30 cm between the top
of the appliance and the ceiling.
Choose a location which is not exposed to sunlight ,
high temperature or humid , as humidity maycause stain.
Pulled out the bottom panel before installation.
The appliance can be adjusted by rolling its two legs in
front the bottom when it is unstable. Rolling in clockwise
can rise up the machine.
The location should be firm and flat. An un-securely
position may cause noise and libration:
(a)The noise may be increased if the floor is not firm.
(b) Put a sheet under the appliance for solving the heat
emission if you need to locate it onto a carpet.
Make sure the adjustable legs are clung to the floor,
and set the appliance slope backward slightly for keeping the doors closed tightly.
PLACEMENT OF FOOD
INSTALLATION INSTRUCTIONS
OPERATION INSTRUCTIONS
1.
2.
3.
4.
5.
6.
There should always be some space between items inside for air circulation.
Food should be
to avoid becoming
dry or with odour.
kept in sealed package
Hot food should be cooled down before placing into the
appliance. Otherwise, interior temperature and electronic
consumption will increase.
Reduce the frequency of door opening can efficiently low
down the electronic consumption.
1.
2.
3.
4.
The temperature of refrigerator can be controlled manually by the
knob. However, the number shown on the knob does not directly
represent the temperature. Instead, the larger the number is, the lower
the interior temperature will be. 0 stands for off. Turn the knob to state
4 when it is normal used, turn it to the state during 4-7 if a lower interior
temperature is required; contrarily, to the state during 4-1, when a
higher one is needed.
