21 EN
Cleaning and Storage
PLEASE NOTE!
■
Clean the device immediately after every use to prevent the formation of germs.
■
Do not use any corrosive or abrasive cleaning agents to clean the device. These may
damage the surfaces.
1. Make sure that the device is disconnected from the mains power!
2. If you have not already done so, remove the mixing bowl (
9
), the splash guard (
7
) and
the used attachment from the basic device (
4
).
3. Clean all used accessories with warm, clear water and a little mild detergent. Clean
all parts under running water. The mixing bowl and the whisk (
3
) can also be cleaned
in the dishwasher.
4. Clean the basic device with a slightly damp, soft cloth and then dry it with a soft cloth.
5. Allow everything to dry completely before the device is reassembled and / or stored
away in a dry, clean place that is out of the reach of children and animals.
Troubleshooting
If the device does not work properly, first check whether you are able to rectify the prob
-
lem yourself. If the problem cannot be solved with the steps that are listed, contact the
customer service department.
Do not attempt to repair an electrical device yourself!
Problem
Possible cause
Fix
The device does not
work.
The mains plug is not in-
serted correctly in the plug
socket.
Correct the fit of the mains
plug.
The plug socket is defective.
Try another plug
socket.
There is no mains voltage.
Check the fuse of the mains
connection.
The switch for adjusting the
speed settings (
2
) is in the
0
position.
Set the switch to a position
between
1
and
6
.
The device is overloaded /
has overheated. The device
is equipped with overload
and overheating protection;
the device switches off if it is
overloaded or overheats.
Switch off the device, pull the
mains plug out of the plug
socket and allow the device
to cool down for approx. 10
minutes. The device is then
ready to be used again.
