Maxx Cold MXCF-19FDHC, Руководство по установке

Страница: 9 / 28

SERVICE AND INSTALLATION MANUAL
www.MaxximumFoodService.com
Cleaning solutions need to be alkaline based or non-chloride based Any cleaner containing
chlorides will damage the protective film of the stainless steel. Chlorides are also commonly found in
hard water, salts, and household and industrial cleaners If cleaners containing chlorides are used, be
sure to rinse and dry thoroughly
Routine cleaning of stainless steel can be done with soap and water Extreme stains or grease should
be cleaned with a non-abrasive cleaner and plastic scrub pad It is always good to rub with the grain
of the steel. There are also stainless steel cleaners available which can restore and preserve the finish
of the steels protective layer
Early signs of stainless steel breakdown can consist of small pits and cracks If this has begun, clean
thoroughly and start to apply stainless steel cleaners in attempt to restore the passivity of the steel
Never use an acid based cleaning solution! Many food products
have an acidic content which can deteriorate the finish. Be sure
to clean the stainless steel surfaces of ALL food products.
GASKET MAINTENANCE
Gaskets require regular cleaning to prevent mold and mildew build up and also to keep the elasticity
of the gasket Gasket cleaning can be done with the use of warm soapy water Avoid full strength
cleaning products on gaskets as this can cause them to become brittle and prevent proper seals
Also, never use sharp tools or knives to scrape or clean the gasket which could possibly tear the
gasket and rip the bellows
Gaskets can easily be replaced and do not require the use of tools or authorized service persons
The gaskets are “Dart” style and can be pulled out of the grove in the door and new gaskets can be
“pressed” back into place
DOORS/HINGES
Over time and with heavy use, door hinges may become loose If the door is beginning to sag, tighten
the screws that mount the hinge brackets to the frame of the unit If the doors are loose or sagging,
this can cause the hinge to pull out of the frame which may damage both the doors and the door
hinges
DRAIN MAINTENANCE
Each unit has a drain located inside the unit which removes the condensation from the evaporator
coil and evaporates it into an external condensate evaporator pan Each drain can become loose
or disconnected from moving or bumping the drain If you notice excessive water accumulation
on the inside of the unit, be sure the drain tube is connected from the evaporator housing to the
condensate evaporator drain pan If water starts to collect underneath the unit, you may want
to check the condensate evaporator drain tube to be sure it is still located inside the drain pan
The leveling of the unit is important as the units are designed to drain properly when on a level
surface. If your floor is not level this can also cause drain problems. Be sure all drain lines are free of
obstructions because this can cause water to back up and overflow the drain pans.
CAUTION
DANGER
NOTE
8