maxwatt MXPW3200, Руководство оператора

Страница: 27 / 38

24

Use a damp cloth to wipe the exterior surfaces clean.

Use a soft bristle to loosen caked-on dirt or oil.

Use a shop-vacuum to pick up any loose dirt and debris.
STORAGE
Fuel and fuel vapour are extremely flammable and explosive.
Fire or explosion from misuse of fuel can cause severe burns or even death.
ENGINE
Fuel can become stale when store for over 30 days. Stale fuel causes acid and gum deposits to form in
the fuel system or crucial carburettor parts. To keep the fuel fresh, add the provided fuel stabiliser
tablets to the fuel tank (read instructions in the back for directions).
Draining the fuel is unnecessary if the fuel stabiliser is used according to the instructions that come with
it. Run the pressure washer engine for a minimum of two minutes, after stabiliser is added to the fuel to
allow it to circulate throughout the engine. The engine and the fuel can be stored for up to 24 months.
DO NOT store fuel from one season to another unless its been treated with fuel stabiliser.
Replace the fuel container, if metal. And if it begins to rust. Rust and dirt and debris can contaminate
fuel supply and components resulting in poor performance and/or internal damage to engine. Fuel
should be stored in newer approved plastic storage containers.
TO PROTECT AGAINST RUST FORMATION DURING STORAGE, OIL THE CYLINDER BORE:

Remove spark plug and pour approximately ½ oz (15ml) of clean engine oil into the cylinder.

Install spark plug and pull starter cord slowly to distribute oil.

Make sure the engine ON/OFF switch is OFF. Slowly pull the starter cord 2 to 3 times to
distribute and coat the cylinder bore with oil. DO NOT start the engine at this time.
Unintentional sparking can cause fire or electric shock. Failure to
observe this warning can cause severe property damage, severe
burns and even death.
Disconnect the spark plug wire from the spark plug and cover the tip of the spark plug wire with
insulating tape and place wire where it cannot come into contact with the spark plug or pressure washer
frame.
PRESSURE PUMP

Drain all the water from the pressure hose, coil and store it in the cradle of the pressure washer
handle.

Drain all the water from the spray gun and the spray wand by holding the spray gun in a vertical
position with the nozzle pointed downward. Squeeze trigger to remove fluids from the spray
gun and spray wand. Store in the spray gun/hose holder.

Store the chemical hose, high pressure hose and the spray wand so they are protected from
damage, such as being run over.