maxwatt MXPW3200, Руководство оператора

Страница: 20 / 38

17
PREPARING THE PRESSURE WASHER
PRESSURE PUMP
The pressure washer is shipped with shipping oil plug to prevent oil leakage from the pump during
shipping. To replace the shipping plug with the breather plug (provided), perform the following:

Using a wrench, remove shipping plug from pressure pump. Discard shipping plug.

Remove the pump breather plug from the parts bag and insert it into the pressure
pump.

Tighten pump breather plug securely by hand. Do not use a wrench to tighten.

Using a wrench to tighten the pump, could strip the threads.

Use the oil level glass window on the side of the pump to ensure that the pump oil
is at mid-point or above.

Add oil to pressure pump if level is below the prescribed level. Use only 30 weight
Non-detergent oil.
ADDING ENGINE OIL

Move the pressure washer outside and place on a flat and level surface.

Remove the engine oil dip stick and place funnel in the oil reservoir.

Pour the supplied engine oil (30 weight) until oil level reaches the threads

Inside the oil reservoir.

Hand tighten oil dip stick and wipe off any spilled oil.
LOW OIL SENSOR
To prevent engine damage caused by an insufficient amount of oil in the crankcase, the engine is
equipped with a low oil sensor. If the oil is below the safe amount, the sensor will activate and will
prevent engine start-up or will stop the running engine.
If the pressure washer shuts off and the oil level is within specifications, check to see if the pressure
washer is sitting at an angle that forces oil to shift.
Place on an even surface to correct this. If the engine fails to start, the oil level may not be sufficient to
deactivate the low oil level sensor. Add oil as described above.