maxwatt MX2000iS, Руководство оператора

Страница: 13 / 64

GENERATOR SET UP
PLANNING THE POWER LOAD
Plan your power load so that you do not exceed the generator’s rate
capacity. To calculate the running and start wattage requirements for
the devices you will be powering, follow the steps on page 18.
SET UP THE PORTABLE POWER SOURCE
This generator is designed to provide up to its maximum power (in wa tt s)
of electrical power. When using the generator as a portable power source,
you can plug electric devices and appliances directly into the generator’s
electrical outlets. This generator is equipped with two SAA approved IP66
rate socket outlets. Make sure you plug each electrical device/appliance
into the correct generator outlet based on the device’s plug configuration
and voltage/amperage rating. NEVER exceed the amperage rating of an
outlet.
Note: You must NOT overload the generator.
Overloading may cause serious damage to the generator and a tt ached
electrical devices.
SET UP AS BUILDING BACK UP
To set up as a building backup, you must arrange for a licensed electrician to
connect the generator to your building’s electrical system via the installation
of an approved transfer switch. The transfer switch must be installed in
accordance with the building’s electrical code and guidelines supplied by
the power company.
A transfer switch does the following:
Safely connects the generator to your building’s electrical system
by isolating your generator from your utility company’s power
lines.
Connects your generator to a critical subset of your building’s
circuits that are needed for emergency power needs.