Manual Group Scan
To initiate manual group scan press
SCN
, then
GRP
.
Scan mode is indicated by the word
"SCAN"
shown in
the upper center portion of the display. When group scan is
actually occurring, the words
"IN SCAN"
appear in the
display in place of the unique group identifier. Group scan
occurs only on those groups enabled by your Maxon
Dealer for the selected system. When an incoming call is
detected, scanning stops and the incoming call is received.
The display changes to indicate the group identifier on
which the call was received and the word
"SCAN"
in the
upper center portion of the display remains. When the
incoming call is complete, after a brief pause, scanning
resumes. To exit group scan mode, press
SCN
and hold
for 2 seconds. (See "Scan Resume Delay" for additional
information regarding the pause).
Transmitting While Scanning
When a message is transmitted while scanning (i.e., the
words
"IN SCAN"
show on the display), Dealer
programming determines if it is transmitted on the "Last
Active" (floating) or on a pre-set "Home" system and group.
The following describes operation for each configuration.
Last Active (Floating) System and Group
During scan (i.e., the words
"IN SCAN"
show on the
display) when you press the
P-T-T
bar on the microphone,
you will transmit on the system and group that were selected
prior to entering scan mode. Once a signal is received, you
will always transmit on that last system group received.
Last active (floating) programming allows you to respond
(transmit) to an incoming call during scan mode
16
