www.maxonamerica.com
3. Radio Operation
7
8
Figure 2-2) How to install and remove the battery
Figure 3-1) MDP-6000 series OLED icon explanation
2.3 Belt Clip Installation and Removal from Radio
Belt clip attaches to the back of the radio above the battery. To attach the belt clip, align the belt clip
to the grooves on the back of the radio as shown the figure 2-3 and push it down (direction 1). Clip will
“click” when locked. To remove the belt clip, push the belt clip locking tab in (direction 2) & pull the belt
clip up (direction 3) at the same time.
MDP-6000 series buttons and knobs are defined as shown in the diagram below (Figure 3-2)
2.4 External Accessory Connector Jack
To connect external accessories as shown in figure 2-4, open the accessory jack cover, align the
radio and the accessory, and then push-in the accessory. To remove the accessory, carefully pull-out
the accessory connector from the middle of the connector and close the accessory cover to re-seal
the jack.
3.1 Power ON/OFF Volume Knob
Rotating the Power On/Off & Volume knob clockwise will turn on the radio and also increase the
volume. There is a chime (ON/OFF programmable) as the radio turns on. Rotating the Power On/Off
& Volume knob counter-clockwise will turn off the radio and also decrease the volume. As the radio
clicks off, there will be a “Goodbye” audio notification (Programmable)..
1
2
3
Battery installation
Battery removal
Figure 2-3) How to install and remove the belt clip
Figure 2-4) External accessory connector jack
1
2
3
Install belt clip
Remove belt clip
Etiquetter(Vibration)
Message In
RSSI
RF Power
VOX
Encryption
SCAN
Channel Number
Zone
D : DMR
A : Analog
Key Lock
Battery Capacity
Zone Number
DM : Direct Mode
RM : Repeater Mode
