Installation & Operation (continued)
Second-Retention Point:
1.
Attach the hook to any of the retention points demonstrated in
Figure 3 (2-FT 40W) and 4 (4-FT 80W). (
Fig 1
)
2.
Route cable around a suitable mounting structure and
feed the clamp side through the sling. (
Fig 2 and 3
)
Retention Cable
• 4’ long with 1/8” diameter stainless steel sling
• Weight capacity of 250 lb.
• If purchasing retention cable from Maxlite, use part
number HLSC250 ( 4ft long, rated for 250 lbs, Stainless steel).
Servicing
• To avoid personal injury, disconnect power to the light and allow the unit to cool down before performing
maintenance.
• Perform visual, electrical, and mechanical inspections on a regular basis. The environment and frequency
of use should determine this. However, it is recommended that checks be made at least once a year.
Frequency of use and environment should determine this.
• The external glass should be cleaned periodically to ensure continued luminaire performance. Clean the
glass with a clean, damp, non-abrasive, lint-free cloth. If this is not sufficient, use a mild soap or a liquid
cleaner. Do not use an abrasive, strong alkaline or acid cleaner as damage may occur.
• Inspect the cooling fins on the luminaire to ensure that they are free of any contamination
(i.e. excessive dust build-up). Clean with a non-abrasive cloth if needed.
• Mechanically check that all parts are properly assembled.
• Electrically check to make sure that all connections are clean and tight.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)this device may not cause harmful interference, and (2)this device must accept any interference
received, including interference that may cause undesired operation
Operating Instructions
MaxLite Hazardous Location Linear Light - CID1
MaxLite Hazardous Location Linear Light - CID1
®
© Copyright 2020. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: 800-555-5629 Fax: 973-244-7333 Email: [email protected]
Page: 3
REV: 10/29/20
