17
16
DANGER!
Potential hazard that will result in serious injury or
loss of life.
• Disconnect the tool from the air compressor before
performing maintenance/service, adjusting, and
when it is not in use.
• Repairs must be performed by a qualified service
technician only. Failure to comply will lead to serious
injury or loss of life.
• Lubrication: If the Air-powered Right Angle
Die Grinder and compressor are not equipped
with an in-line lubrication system, place up
to 6 drops of pneumatic tool oil into the air
inlet before each work day or after every 2
hours of continuous use, depending on the
characteristics of the workpiece used.
• Clean the Air-powered Right Angle Die Grinder after use.
• Check the air supply for power loss or erratic action due to the following
reasons:
– excessive drain, moisture, or restriction on the air pipe.
– improper size or type of hose connectors.
• Check whether there are grit or gum deposits in the grinder, flush the
grinder with gum solvent oil or an equal mixture of SAE No 10 oil and
paraffin, and allow tool to dry before use.
• Disconnect the tool from the air supply, clean the tool, and store the tool
in a safe, dry, childproof location.
Worn or broken
parts
X
X
Replace worn or
broken parts
X
Lubrication
See below
Pneumatic
X
MAINTENANCE
REQUIRED
DESCRIPTION
TOOLS OR
MATERIALS
REQUIRED
MAXIMUM SERVICE INTERVAL
Each use or
every 2 hrs
Monthly
As
needed
In-depth inspection
tool oil
NOTE:
When temperatures are below freezing, maintain
the tool in a warm condition using any safe,convenient
method.
model no. 058-9367-8 | contact us 1-888-670-6682
TM
